1st Gen Lunchtable Thread - General Discussion

ahhh do you have access to one at work?

those cuts are clean

 

I do but it's been so dead there that they haven't needed me at all. I've got keys for the shop but don't wanna go just to cut stuff (other town) after hours.

I just need to get an Evolution saw but really wanted the EVO185 that's out of stock everywhere.

 

The larger Evolution is available, but that'll require some dedicated work space and though I have room, I value real estate in my garage.

That and I don't expect to have to cut larger than 2" square tubing.

 

Flip top work cabinet, you can put two tools in one space then

 

Oh man that's legit...but I relocated my air compressor to underneath the bench that could've been repurposed as such.



Was thinking the saw could sit temporarily on the wood bench or small table when not in use.

I'll have one of those portable stand/stations to deploy when I need to use it.

 

@Wulf
@Speedytech7

You guys have bigger shops/garages, anything major either of you doing?

 

@eon_blue is gonna end up as a frog in the next life

 

that poor frog has been enslaved

 

@Taco critter

https://www.instagram.com/reel/CfueTNYlpqO/?igshid=MDJmNzVkMjY=

 

@04Pre_Runner have you gotten that hernia looked at yet

 

I’m just going to live with it for now. If the doctor at my appointment in September decides to take me seriously I’ll get it looked at. But I’m not going to beg a doctor to do their job.

I’ve had horrible luck with healthcare in this town and I’m not the only one. Hopefully I’m not a biological female with a dick.

 

Shiny, but you can really tell toyota painted everything at different factories haha. Never been in a wreck I might ad, that shit is stock

 

I wish they'd bring back those 90's decals, though it would probably look pretty weird on today's trucks

 

you don't just run the saw on the floor?

 

I think the tacoma rear is my current big project, after we talked about it the other day I'm gonna try and swap the bottle I have before I drop more money for a new one...I'm tempted to say fuck it and order a built 9" rear but really I need to just stick to the basics til I have energy to actually crank through a big project again lol

I've been knocking out smaller stuff when i have the energy to work on stuff for 30-60 minutes. I just added more weather sealing to the shop and replaced a busted window the other day. Need to do the alt and maybe change steering reservoir on the crawler to the PSC one I have on the shelf before I wheel it

 

I'm just going to leave this right here

https://youtu.be/kucefQ6sYbo

 

When cutting long stock we put it down on the floor, but otherwise use the evo stand, it is pretty sturdy