Shop Time w/T.W. Friends

I do like mustard. Might have to get this stuff sometime and try it.

 

I actually just used JB Weld epoxy on a lamp my kiddo cracked. Hopefully it holds it together. Not sure how I feel using a bulb with it despite the heat ratings lol.

 

Get a warm color temp LED for it, basically no heat at all compared to incandescent.

 

Thanks!

 

I forgot how much heat old bulbs put off until a trip to my aunt's place recently. I went to turn a lamp off with an old bulb and wow, the heat was awful.

 

I pretty much recalculate heating/AC load every time they swap out a floor from fluorescent to LED lighting. Incandescent lighting is even greater but not many of those left.

 

​

 

Just finished drawing up the plans for the new bleachers that were installed. Final square footage came out to 10,000.923. I might have to fudge it a bit to get rid of that remainder.

 

Just allow for foot room. Should be dead nuts then.

 

No possibility of rounding up to 10,001 sq ft, huh?

 

Stretching the trackside face of the bleachers 11/128" puts me at 10,000.017.

23/256" was just a hair too much.

 

Absolutely could have. All of our data is rounded up or down to whole numbers anyway.

Sometimes I just enjoy making my life that tiny little bit more difficult!

 

Why the cheap seats are the cheap seats. Gotta see the Nosebleed calc’s before it really sinks in.

 

The new Techs no trouble shooting that can not be figured out by plugging in a scanner.

After the Cluster what next a New Wiring harness ??

 

Under warranty I hope...

 

Interesting what is the real difference in temperature between low temperature and high in epoxies .

I might be seeing a heat related failure due to heat soaking the engine on hot days running 8 to 10 hours.

 

No clue what they will say next. I'm hoping there is no next.

At this point, if the gas gauge moves at all I'm going to leave well enough alone, I think.

 

It is, but only just barely!