Fitting 35’s with minimal trimming NOW ADDING LONG TRAVEL AND 934 CV’s

Much better looking.

 

Is anyone running the tundra rack with 934 axles?

 

I am

 

No issues? How close is it?

 

Extraordinarily close and took some fucking around with shims to get the clearances I needed. No issues though now that it’s all said and done.

 

What did you shim, the mounting points?

 

The mounting points to rotate the rack forward a smidge as well as the poly motor mounts to lift it up a bit. I think I also put shims under the rack itself, in between it and the frame. I don’t recall. I just know it took a lot of fine tuning to get it to where it needed to be.

 

Did you have to shorten the steering shaft?

 

Yes, I cut out the entire part and welded in some dom tubing.

 

All good info, thank you. Any other advice?

 

My Instagram is 4lo_pro and on my page I have a story highlight labeled “tundra rack” with a whole bunch of shit in there.

 

I've been following you for a while. I'll dig in and see what's up, thx.

 

Feel free to DM me on there if you need any more specifics.

 

Super excited to do lower pivots, 4” kit, 934, bypass shocks, bump stops, slide rack and Howe TC pump on this thing... the 39” BFG’s look wild

 

How much work did they do to fit those?! Do they measure small like most bfg?

 

Never said they fit and they are pretty close to 39’s

 

They are a self clearancing setup at the moment. They run small ~38.25“. 37s is the tallest without cutting into anything major. Hoping a little more alignment goes a long way. Would like to smash 40s

Thanks Harry for taking her in.. I know I don't have all the fancy stuff you guys are doing but I'm going to see this project through! May take a couple years but if you can smuggle me in time to time, we'll git'er dun!

 

looks like it’s getting the full front works! I’m excited to see this one go.

 

oh shit i never even thought about that clearance with the 934's...probably just shim the rack up...i still want to move it forward one of these days but i've got to custom build front diff mounts and i just don't have the time until probably next year...