What Have You Done To Your 3rd Gen Today?

Jesus. How do people not secure their load..

 

Never seem to have those lower arm skids when the sales are up lol

 

Just got a pair of RXT today!

 

nice! I got mine a few days ago and then was sent out of town for work….

 

Twan a Kool dude in my book he helped me out today with my regear appointment. Them Dudes got videos/receipts. Of them off-roading sounds like u have a personal issue.‍♂️They definitely motivate me it’s a brotherhood.

 

Did you do the U-bolt flip or opt for standard?

 

I just did the standard. I have sumo springs and I haven’t looked to see how hard it is to get them to work with a flip kit. I also have not pulled the trigger on a lift yet, so I’m going to run option 1 with about 500lbs in the back full time. Should give me about .5 inch lift over stock in the back if my math is right. Once I get the lift I’ll swap out to option 2 or 3 and think about the flip kit

 

If it makes ya feel any better, I did the bumpers, winch and lights first all at the same time….in April. The Auxbeam has been 3m taped in the center cubby hole since then waiting for me to do this…finding the plate was the delay. When summer hit, that 3m tape would let go about every 3-4 days. That was actually what motivated me to get it found (was expensive) ordered and installed lol but it’s done!!

 

Not sure what you mean by bolts. There are no bolts, it just pops out…well with a bit of effort and plastic trim tools anyway. Yes they also pop back in. There are screws on the Auxbeam for the mount that’s not needed for this. The plate had slots where those same screws hold it to the switch plate. I did have widen two just a hair because they didn’t line up ‘perfectly’.

 

yes it is .....I'll just keep grabbing the steering wheel or the roof

 

Nobody checks the muffler bearings and the Jenson rods either.

 

The flyback transformer is often neglected.

 

Boooooo no practicality ever.

 

@NACAircrew that you? Takes sound similar

 

damn! Do you have any photos of the suspension? The rear set up looks gnarly fun

 

https://youtu.be/nbJheOvJzCM The 6 minute mark is what I was referring to. Thanks for answering though. It seems to replace my factory cubby with the meso custom cubby I won’t have to remove those bolts. I’ll just use the trim tools like you said.

 

Hey. I put the puddle pods on my truck from meso. I just used a long piece of wire to feed the wires through. It was a PITA but I got it to work. Just my 2cents. Good luck

 

Been looking at them as well. def nice to have. just wonder if theyre DOT approved. also looking at these. anyone have these?
https://www.ktjo4x4.com/collections...eals/products/tacoma-power-folding-mirrors-3g

 

METHOD FUCKIN 701s! Ive had mine on my taco for about a year and a half now, and I absolutley love them. ive been reccomending them to people since i got them, and im stoked to see more people putting them on their tacos now!!

 

Don't buy from her. She's banned on this site for a reason.