Wiring Diagram for 360 degree camera side mirrors?

Anyone have a wiring diagram for side mirrors with the tech package (360 degree camera)? I'm trying to adapt (tow) mirrors without cameras to my 2021 taco.

Because of the addition of the camera, I believe, Toyota changed the connector to a different configuration from non-tech/previous years. With the diagram and connector part numbers, I'm hoping to find/purchase the male connectors that will plug into my truck, and the females from a non-camera truck, so I can make adapters, and hence be able to put everything back if/when I sell the truck someday.

 

The part #'s are embossed on the connectors. Removing the door panel is easy.

 

Here's a start:

https://www.hi-1000ec.com/product/1221
https://www.hi-1000ec.com/product/1214
https://www.hi-1000ec.com/product/2711
https://www.hi-1000ec.com/product/2710

 

Thanks Caribe

 

https://www.youtube.com/watch?v=uOPjVmJepQY

 

Which tow mirrors are you going to install?

 

Ah I was hoping to see if someone may have tried swapping out the factory cameras for something a bit higher quality. The stock ones are surprisingly bad.

 

The CAN-BUS part is the road block...

 

It's these. They're great quality, much larger than the OEM mirrors, and can extend far enough out so I can see past my trailer. And more to the point, I now own them since I failed to return them for a full refund in the time allowed. Apparently a version of these with camera doesn't exist, today.
I'm willing to sacrifice the 360 degree camera to be able to change lanes safely. Also I have a Pioneer head unit that I had in my 2016 that I will probably use to replace the OEM head unit at some point, and it supports rear/front camera but not sides, and supports wireless CarPlay.

 

Do you have the wiring info on those?

 

Sample pigtail:

 

You've saved me countless hours of searching for this information. Thank you!

 

What wires are there from the towing mirror?

 

Maybe...verify before you pin the mating connector.

 

Thanks, I'll check before I wire anything up. I have the mapping, pretty much, except for the turn signal. I see that pins 10 and 11 in the 12-pin harness are for the turn signal, but I don't see any pinouts in the 16-pin harness. If you don't have that, I can probably figure it out by process of elimination at this point. From the pinouts given, it has to be a pair within 2, 6, 14 and 16 (the others are already used, or for camera). I can probably figure it out when I pull the door panel back off.

 

Excellent, let US know what you get. Turn Signal Ground may be shared.