1st Gen Lunchtable Thread - General Discussion

Could have*

 

damn that's a good friend that would wait 500 billion years for his buddy to return

 

I went down a Quora rabbit hole this morning on the topic of "What memory would you erase if you could"....reading all those replies was not a great way to start the day.

 

Quora is a site everyone could have blocked by default and not miss a thing by having the access removed.

 

Should have

 

This is why I keep coming back; 2' by 4' long, 1/4" steel plate weighs 81lbs.

I got rung up for only 40lbs; veteran discount on the hush hush

EDIT: it's actually 5 ft long by 22 in wide. Using the small table for leverage to cut it up -

 

Idk bout it

 

Gonna suck when someone backs into it or he bumps a parking lot curb stop

 

Should've gone rear mount

 

I'd probably wrap a tube bar with some fat 9" lights around it so it's less visible. It's got a Coyote swap so I'm cool with the placement lol

 

I just feel like it's not a daily

 

meme courtesy @Speedytech7

 

Let me run it into 4' of river water to test it out.

 

this low-res image is what the world looks like without my contacts in

 

Little blowback from using drag on such thick steel (you'll notice it the first 3 inches of the cut up top)





Put the regular tip back on and it cuts 1/4" as if it were scissors to paper



@Abeyancer feathers gonna get ruffled when he sees that galvanized sheet I always use underneath

 

Could have done

 

I just worry about your health man, I've been sick from galvanized coatings burning off and I don't wish that kinda pain on anyone

 

Nooooo, I'm not cutting or welding on it.

I'm using it to catch the slag underneath stuff.

That's why I passed up that good paying job welding stainless and galvanized, the galvanized was a daily thing. That and it was a bit of a drive.