1st Gen Lunchtable Thread - General Discussion

suggestion, find 16" or 17" Taco rims off Marketplace, then it opens a whole world of tyre size possiblities.

...
Done

 

And yes, I wrote the dimensions on said parts for you to reference in case you need

 

UCAs anyone?

 

yeah there's a thread on here somewhere about them in the 3rd gen section, I think they're rebranded Icons?

 

Woah, the taco passed inspection first try. Amazing

 

Fuck, ran out of long cardboard pieces...

May have to run to the post office for some of those free priority mailing boxes

 

Physical or just a obd scan?

 

Physical.


Check engine light was shining bright.

 

Thought I might get dinged on rear bumper height because the law is ambiguous, but no problem

 

CA - "your brakes are at 5%, tail lights are out, no tread on your tires....but your OBD scan was good, here's your registration"

 

Nice, the physical usually the hard part?

 

My left front wheel is squealing because the pads are almost done. Also not a problem.


For some reason my renewal is in September, even though I initially registered it in December. This state is weird.

 

Dunno. My vehicles are never that bad, but there’s a couple things I wasn’t certain about with the flatbed . Probably would have failed in an emissions county

 

what are they looking for with the physical inspection then?

 

Steeper angle or call it good?

 

Safety stuff - lights, brakes (does it stop?), wipers, etc

 

I’m a big fan of 14 degrees

 

gotcha, so long as they work lol

 

I'm keen on 17

 

Heresy