1st Gen Lunchtable Thread - General Discussion

Still have 13 pro. I hadn’t upgraded since the 8 before this one…the 14 looks good but I don’t think I’d upgrade. I’m using smaller sensor pocket cameras more than my phone now anyway. You might do better to snag a discounted 13 if the price is right. But if you get a good chunk for your phone on trade, 14 is worth it.

 

I got the 14 yesterday. Upgraded from an 11. Seems good.

 

Ran my iPhone SE for 5ish years. I'll hopefully run this 13 Mini for the same.

 

@Blue92

May be a dumb question but, are electrical boxes for 220V limited to a single plug? I'm guessing yes but I would like two 220V near each other for two reasons.

My plasma cutter and welder sit next to each other.

A run of conduit exists for my 1 outlet now, and would be easier to use the same area for another run straight to my panel.

No, I do not plan on running both on the same wiring or breaker. I'll be adding a dedicated line on its own breaker.

Just want to alleviate the inconvenience of disconnecting one item for another and vice versa.

 

I dont think theres any stipulations to doing that. Though I personally dont like having two separate power feeds in the same J box if I dont have to.

 

@Yota X

https://www.instagram.com/reel/CipH1IipcJr/?igshid=MTUyMWE5Zjg=

 

I didn't like the idea either, but it was more out of sheer convenience. That and I wasn't sure such a box existed.

 

Yeah I wish I got the mini

 

There’s a few. Some, like the punkt mp01 seem like they’re a bit too trendy and delicate. I’m trying out a sonim xp5s right now, and it’s a bit chunkier than I expected but the price was right.
/r/dumbphones has a page on GitHub that tracks what dumbphones do what.


Yeah I’d love an iPhone like that. Especially if the battery life was good. I charged the sonim up to 85% on Friday and it’s currently at… 63%.

 

You maybe could use a 4 gang box.

 

Thats legit. When I do my tankless water heater I’m gonna use my laser for sure!

 

Goodluck finding a cover though.

 

So I just accidentally topped off the celica with a quart of gear lube before doing a full throttle pull

The bearings should be extra fine

 

@Speedytech7
@Yota X

More fab work today?

 

Picking these up today
2nd Gen Tacoma 2005-2015 Icon 2.5 (NEEDS REBUILD)
https://classifieds.ksl.com/listing/69431205

 

And these for 175 total

 

Am I cool like you now? Having a 2nd gen.

 

No

 

Long time listener first time poster in this thread- little project I am trying. I have a MCM Fab +3.5 LT kit. It has upper 1 inch uniballs. I try to keep them clean and greased, but they get so dirty so quick. I used some PVC pieces, bed liner, and general black silicone. I have yet to cycle the suspension to see if it will even work or if the top of the uniball bolt will touch the sides of the PVC. If it breaks, I’ll come up with something else. Has anyone done something similar? I looked far and wide on the google machine and have yet to find anything. I was thinking maybe somebody who has access to a 3d printer can come up with something. Lemme here your opinions.