What Have You Done To Your 3rd Gen Today?

Swapped out the bumper caps and got rid of the chrome.

 

That’s amazing

 

Same, but different....I didn't like the Gen Three Tacoma at first...now I own one.

 

@bameintzer

That's a Mighty Long Bed Sport you got there...!!!

I'm told Long Beds are better for towing.

Either way, you got a skewp...and that's what matters! lol

EDIT: I've yet to see if my short bed Sport will fit in our 2-car garage; I think it will.

 

I closed my eyes for 3 seconds and it vanished.

I took advantage of crazy trade in values earlier this year.

 

A/C Drain reroute!
not my best work; but it's been forever since I've done anything mechanical

 

Front bumper restore complete. Really prefer the stock look. Wasn’t a big fan of the aftermarket one.

- Installed replacement fender flares
- Installed replacement fender flare inner liner
- Installed AC Drip relocate

 

How do these attach, without drilling?

 

Oh SH!T ! That looks good.

 

Great looking rig. Was looking at those same SCS wheels but got RRW ones instead.

 

Set up a dash cam. Not going through the hassle of an insurance claim again.

 

Looks good which one you go with?

 

That really stinks, but Doesn't surprise me. I think this was due to the distributor screwing up. Shell is top tier and reputable, and this particular station is better than most, as evidenced by the fact that the owner made me whole. He could have esily just said F off and there would be little I could do about it.

 

Rexing V1PPLUS
Not too bad for a front and rear setup

 

two screws attached to a back plate.

 

Knocked a few off the laundry list:

-OEM Bed Mat
-Bakflip F1 tonneau

Still need to drill the holes for the drains, which I’ll do into the front of the bed and use grommets probably this weekend.



I also got a gas cap holder from Etsy. NOT because I don’t think the fuel door clamp isn’t capable of holding the gas cap by the tether, but because I find the tether annoying. My hand is somewhat large and when I unthread the cap, it likes to tug on the door and pull it semi closed. So I cut the tether off and got a gas cap holder. I like this setup better.



Got it from 3bMakers on Etsy:
https://www.etsy.com/listing/884791870/

 

Okay, so the plates act like a clamp, and there's no damage to the vent?

 

You have a link to those battery terminals? Tia

 

Are those led lights behind the grill at the bottom?