What Have You Done To Your 2nd Gen Tacoma Today?

Oooh she thiccc

 

It’s the warn low profile front winch bumper, not sure of the part# but if you google those words it should come up. I ordered from 4 wheel parts but other places might have better prices. The install is easy as long as you have an angle grinder and some snips for cutting plastic.

 

Nice ! By chance do know a part # for tha pads that go in these bad boys?

 

Very nice! I thought they didnt make these for 2nd Gen Tacomas. What year is your truck?

 

Noticed I was missing a headlight mounting bolt, had a bolt that fit lying around. No more shaky light on the bumps lol

 

It's a 2014. I read a couple posts on here that the 3rd gen seat covers fit 2nd gens. So I waited until there was a set on Rough Country's scratch and dent ebay site. Got the full set for $100 and I can't find anything wrong with them. They fit like a glove, I'm super impressed.

 

@RedWings89 Where did you get the RC seat covers for a second gen?

 

See above. The 3rd gen covers fit 2nd gen as well. Got them from their scratch and dent ebay store for $100

 

Made the move to 37's

 

Any chance you have a full on side shot of your truck? I’ve been thinking about putting my flares back on but wasn’t sure how some black bushwhackers would look on a bright red truck. I like how they look on your front!

 

It’s fall and truck was due for service and a smog so:

Last weekend EGR valve/hose replacement, pulled skids, greased the U-Joints, UCAs, greasable leaf spring bolts (Dobinsons) and the tie rod ends. Replaced engine and cabin air filters. The front drive shaft is so much easier to grease with the skids off.

This week serviced the f/r differential gear oil and the transfer case oil. Of course I ran just a little short on gear oil and had to make an evening run to the store for another quart. And used like 4oz from the bottle. Such is life.

Today had the transmission serviced (paid for that at the independent transmission shop).

Tomorrow Smog and free oil change from my independent repair shop. I normally change my own oil, but remembered the ‘free oil change’ they gave me when I had the truck smogged a couple years ago. They do good work so I’ll let them do it.

Then I’ll clean up the throttle body, MAF sensor, snug/repair/remove rattling heat shields and drill/tap the damaged thread on one skid plate hole and then get the skids put back on and call it a day.

 

Threw up the flag

 

Picked up a Hitchgate SOLO for $680 and finally got it on!

 

Installed a 10000k winch

 

This is on 35" nitto's. Also, the fenders themselves have been trimmed around 2" or so.

 

Right on man thanks, love the reg cab!

 

Where did you get that blacked out Toyota emblem? I can't seem to find one for my 2010. The chrome is chipping off and I'm trying to do away with all the chrome anyway.

 

2007 DCLB XSP bought new almost 16 years ago. Recently leveled with Bilstein 6112s up front and 5100s in rear. Has slight upward lean. Prefer the factory rake, so will most likely add a leaf in the near future. Went from highway 255/50/20 to TOYO Open Country AT3s in 275/55/20.

 

I wrapped it. Unfortunately they only make the nice ones for the 12-15s

 

Yeah that's all I've been finding.