What Have You Done To Your 3rd Gen Today?

I installed my 5100 right where the auto phone charger is located and away from the sun. I frequent 4C - good place to chat.

 

Maybe. But nobody ever says; This is my favorite song. Crank it right!

 

Yessir. This is what I got

$24 Toyota Genuine Parts - Cap Assy, Oil Filter (15620-31060)

https://www.amazon.com/gp/product/B008BHP68A?ie=UTF8

 

Same cap fits RAV4. I swapped plastic ones for this on both of the vehicles.
4 years ago they were $15.97 apiece.

 

Drove it to work.
2 years old
10,000 kms
333 kms left in the tank

Likely never see those numbers again

 

Thanx

We are very close to testing and adjusting the shocks.

MCM Motorsports in Phoenix specializes in racing and off-road customization

And just around the corner is AZ Wire Pro

 

How would you ever see those numbers again, unless you bought another truck?

 

Clean and state-of-the-art was the look we are going for to be placed in off-road expo and webpage ads

 

Here's my latest video in my camper build series. Thanks for checking it out.

https://youtu.be/lxu6W_hZiP8

 

Sounds like a good argument for another truck with the wife

 

DO it

 

I would try to keep off bumper. Maybe like this (quickie edits)

 

Just wanted to match my wheels

 

Yah, you’re right. That is an issue I haven’t quite resolved in my head. As they are they’re the perfect length to keep the plate in line with the front end, so I don’t really want to do anything that would shorten them. I like your idea of putting some kind of rubber or plastic bumpers on the brackets. I’ll experiment with that idea for awhile.

 

Perhaps get a package of these and you can experiment.

$8 48PCS 4 Size Anti Scratch Screw-on Round Black Rubber Feet Bumpers Pads W/Matching Screws & Built-in Stainless-Steel Washer Carpet Floor Protectors for Cutting Board Amps Cabinet Tables Chair Sofa

https://www.amazon.com/Scratch-Bump...w-on+Round+Black+Rubber&qid=1667332195&sr=8-1

 

That’sa pretty cool trick with the photoshop. I got it you’re right. I added the brackets to keep the wind from angling the plate downward. Another poster suggested using rubber bumpers on the brackets to prevent puncturing the valence. Short story, yes! It’s been on my mind.

 

noticed some squeaking so figured it was time for the yearly retighten of the bed rack and rock sliders.

 

Made my own brackets for a onx6 since no one makes them especially for a 10” bar.

 

If you can find a smaller pack of these, could be in the random section in the hardware aisle

$40 Caplugs 99390521 Plastic Rectangular Finishing Cap with Flat End Grip. VRF-125X1500-16, Vinyl, Length 1.000" ID 1.500", Black (Pack of 40)

https://www.amazon.com/dp/B077DBVFNW

 

Gave it a much needed bath.