What Have You Done To Your 3rd Gen Today?

It’s expensive. $2695 for full Ceramic Pro (CP) Treatment. They do a full paint correction and then 4 layers of CP 9H on paintwork/trim, 1 layer of CP Light on paintwork/trim, 1 layer of CP Wheel and Caliper on wheel faces/barrels, 2 layers of CP Rain on windshield/glass. It’s a lifetime warranty, or 5 years from the last annual inspection. I had bad staining on the roof from pollen and I park my truck outside so I figured that they would get rid of everything in the paint better than I could and the ceramic makes it easier to clean off next time.

 

Did you have any issues installing it? I tried and mine won’t allow the console to go back far enough to get the clips in. It seems like the new cups hit the crossbar in the console.

 

Take a look at about 2:14 on this install video: https://youtu.be/qxdZdo__4l8

Essentially, you want to loosen this screw and move that crossbar as far back as you can.

 

Nice wera

 

That’s a screenshot from the Z Precision install video, but I too have gone full Wera with screwdrivers and smaller ratchets. Great stuff!

 

No. When I was looking to buy a couple years ago, I thought about swapping out the lights for LEDs. The LED Light guru here, crashnburn80, said that the Toyota OEM LEDs were better than any after market. I bought the tech package because it came with LED headlamps and driving lamps, and I sure do like them. I did swap out the rear backup lights for LEDs.

 

I'm guessing that (a) there is something exciting is inside those boxes; (b) you are going to have a busy weekend; or (c) both.

 

Had a friend RIP out front passenger and driver side tinted and replace with 20%, as pictured. Pics of truck will come tomorrow.

 

isnt that $6 a month?

 

Little bit of column a, little bit of column b. Unfortunately, I can't get to the install this weekend as the truck is going to get the roof wrapped and a few other things on Monday. According to the installer, he needs to get under the headliner in order to access the shark fin antenna. In order to make the job a little easier for him, I'm going to remove the c-pillar trim and the rear sets. Not only is that something that needs to be done for the seat delete, but it should make his job a little easier.

 

Dealer in my area wants $1799 installed not including tires for the 4Runner TRD pro wheels. I’m going to have to pass.

 

i forgot about it now i am triggered again
another load of ecar fuel

 

Just got a MBRP cat back exhaust system on my 2016 4x4 Off Road Access Cab.

The exhaust sounds great, a nice rumble at low RPM and no drone on the highway.

 

Are those just small shallow tool boxes?

 

nice box

 

Beautiful. Do you mind sharing what brand ceramic and how much it cost?

 

From another post the OP answered
‘It’s expensive. $2695 for full Ceramic Pro (CP) Treatment. They do a full paint correction and then 4 layers of CP 9H on paintwork/trim, 1 layer of CP Light on paintwork/trim, 1 layer of CP Wheel and Caliper on wheel faces/barrels, 2 layers of CP Rain on windshield/glass. It’s a lifetime warranty, or 5 years from the last annual inspection. I had bad staining on the roof from pollen and I park my truck outside so I figured that theywould get rid of everything in the paintbetter than I could and the ceramicmakes it easier to clean off next time.’

 

See the above post and https://ceramicpro.com/ceramic-coating-for-cars-ceramic-pro/

 

How long did it take to get it? I had ordered the full delete but cancelled when they told me it would take 10 weeks.