1st Gen Lunchtable Thread - General Discussion

Yeah, I feel ya there.

Think I just miss the whole "being able to bundle up" when you're cold thing.

Tell you what, your place felt stupid comfy when we were there! I could easily see myself passing out if I laid back on that couch.

 

You make me wish I had more local friends

 

Don't sell yourself short

There are several here I still want to put a face to, but you're on the wrong damn side of the US; can't risk getting rust on our trucks.

 

If I get a co driver I’ll make the drive. My buddy from school moved to Colorado that’ll probably be my first trip in the 95

 

Well I just had a Mercedes diesel runaway on me in the shop. Nearly asphyxiated us with all the soot. Had to kill it with a fire extinguisher. Disconnected fuel and was choking the turbo with a mud flap and the fucker still was turning at 2,000 RPM at least.

 

I checked out his IG; it's him doing the same climb over and over again.

He wouldn't make it through a single Black Diamond trail out here, even in an SVRA park like Hollister Hills.

What a moron.

 

@Das it mang

Not sure what happened to the 8350 results, but I found out that I had old Firestrike scores saved from years back (they save online).

I clocked an 8150 to 4.5ghz, and replaced it with a 4670k which clocked even lower. Though it still scored higher in 3DMark.

Afterward, I ran the 6700k for a good 6 years until now -

 

I'm going to guess the extinguisher isn't good for the motor?

 

No it is not. It's like pouring sand blasting powder in it.

 

Okay, so this oven is really fancy and does have convection. I have a total of five coils - two broil elements, two bake elements, and a single convection element in the upper oven. How should I wire this for best efficiency?

 

The old ones from the 80s had a kill valve on the side of the engine near the valve cover.

 

I bought that cover from Barnes I think. Welds suck. Super flat. It’s funny cause like 3 days ago someone was looking at it and was like those are really nice, did you do them? I said na, I weld a lot nicer than that. I think he thought I was joking.

 

Unfortunately that didn't work

 

Gonna go down to the shelter on thursday to meet this girl and maybe a few others too

 

Gates is my go to when I can’t get Toyota for hoses and belts. Seem quality.

 

Oooh she might have some husky in her being bi-eyed.

What a cutie

 

Yeah the heterochromia is neato, never know what breeds have all that. Think collies and such get it regularly.

 

That's for fuel only

 

And it weren't working anyway. Literally yanked the fuel inlet hose from the lift pump, choked it with all the pressure two full grown men can possibly exert on a roughly 2.25" hole (damn that sentence outta context is hot AF) and still the MF refused to die. Was sucking air from somewhere which is odd cause we replaced every intake o ring. So probably a bad manifold gasket or a leaking valve cover and it was pulling through valve guides.

 

Damn, that must have been freaky

I dunno how true it is but I've heard if the rings heat up enough to melt they can pull air past the rings through the crankcase too