GoFastCamper GFC Mods, Tips, and Tricks thread.

The $1750 was for the White Glove shipping/install to your house. For us east coasters, it's the only way unless you're driving to MT.

If you pick up from one of their new dealer locations, there's no shipping charge.

 

Well in the email they sent shipping to a residential location was just an extra $50 on top lol. but this was also nearly a year ago. And I don't think they had any dealerships at the time.

 

I don't see how they can do that long term without raising prices again

 

They will raise prices at the beginning of next year.

 

Damn do you know how much?

 

If its like previous years $500? They will announce it in December I think, or when they start promoting buying it this year

 

Long process, but I think im ready for a test run before I order a few more parts..

 

Clean!

 

How are you securing the heater to the box? Could you attach another exhaust hose to the outside portion of the exhaust pass through?

 

I trimmed the bracket that came with the heater. We will see if it's sturdy enough to do that.

yes, I believe another exhaust could be attached to the flush mount of the pass through.

 

Would that additional exhaust line be the same diameter as the internal one?

 

did you ever find a dimmer switch? I have had very good results with

$33 Mini LED Dimmer Knob with Rotary Control Switch - pwm dimming for 12-24V LEDs, Fully Waterproof, dim up to 4.8A at 12V or 2.4A at 24V: car Automotive, Marine, Low Voltage Under Cabinet Lights

this one

 

Should be. I wasn't planning on putting anything there, but maybe a quick check with a caliper could help

 

Oh I’ve been looking for one of these but have been hoping for a first hand recommendation. Thanks!

 

of course! I use it with the mattgecko leds and it works like a dream

 

https://youtube.com/shorts/i8yiLQZFhn4?feature=share

I think I might be replacing the controller to the Knob switch. May also have some extra parts to sell too

 

How long have you run it? There's definitely some burn off of assembly oil that happens when I run webastos for the first like 20 minutes

 

10-15 min.

I ordered this knob switch. I don't really need the altitude adjustment or ability to change the hertz. Hoping i can sell old parts

 

where in NJ are you? You can see mine if you want. I’m in 07755.

 

Modified a weld on nut to tighten in the t-slot on the bed and installed the chalk bag cup holders.



I used 3/8 stainless hardware. The outer washer is to hold the chalk bag on then I used nyloc nuts before a larger washer that allowed everything to be tightened.


Here's the test fit showing how the spot weld nuts worked. Like the GFC fasteners, I could insert it into the track then it locked in place as I tightened it. This was a better option for me than having to remove the rear GFC mount to slide a T-nut past it.


Everything assembled and ready to install.


They're a bit large for 12oz cans but a coozie and something to help raise it up will solve that.


For now I'll just toss a couple of these in there.