1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Another P0100

Discussion in '1st Gen. Tacomas (1995-2004)' started by Ironworker84, Nov 17, 2022.

  1. Nov 17, 2022 at 3:32 PM
    #1
    Ironworker84

    Ironworker84 [OP] Well-Known Member

    Joined:
    Nov 4, 2018
    Member:
    #271625
    Messages:
    183
    Gender:
    Male
    First Name:
    Eric
    Vehicle:
    2001 White Tacoma 4X4
    Fresh motor and supercharger installed. Old wire harness. The MAF has been repinned more times than I want to admit chasing the notorious P0100 code. Fresh sensor today and still the same cel. Does anyone have the wiring diagram for the ECM on a 2001 tacoma 3.4. I can't chase down what's what correctly until I know I have the correct wiring order. I want to say it's
    1-B+, 2-VG, 3-THA, 4-E2G, 5-E2 or
    1-B+, 2-E2, 3-THA, 4-VG, 5-E2G. I should mention I installed a split second ftc1 controller. Any ideas so I can get this bitch going.
     
  2. Nov 17, 2022 at 3:34 PM
    #2
    1997tacomav6

    1997tacomav6 V6 5sp,RegCab,TVS1320 Supercharger,Haltech, 800k

    Joined:
    Oct 5, 2013
    Member:
    #113940
    Messages:
    10,398
    Gender:
    Male
    First Name:
    John
    Denver
    Vehicle:
    97 reg cab, v6 5sp 300hp supercharged, Methonal Injection, 800,001 plus miles, Original Owner
    V6 5sp,RegCab,TVS1320 Supercharger, 56mm pulley, methanol injected Haltech ECU, AC Tvs1320 supercharger,(MUST DO) every 125,000- 150,000 needs rebuild Projector headlights HID 5 speed manual Amsoil for all drive train Smaller 56mm custom pulley, (MUST DO) 2004 DESNO fuel injectors, zero ping ping, 2004 side door mirrors Dick Cepek Rims, Michelin tires LTX, ATM Pathfinders Dynopro ATM ( that last 100,000 miles) Now running Dynopro ATM mud and snow tires KN cold air intake Cat back dual exhaust with ss exhaust tip, Raised exhaust tail pipe to 2" below body line Optima*dry cell battery,red top Alpine sirius radio, 200 watt amp, focal is165 split door pod speakers Focal door speakers Subwoffer behind seat Viper alarm, Electric Locks Dark tinted windows, bucket seats corbeau lg1 Tacoma Rubber floor mats TRD fender extenders, Bilstien shocks, King shocks JBA UCA trailer iv hitch, electric brake control, Drilled slotted brakes, High carbon steel (MUST DO) EBS green stuff 7000 series pads(MUST DO) TRD engine oil cap TRD stick shift, Marlin crawl shift kit. Rear sliding window 2002 4Runner functional hood scoop cut into Tacoma hood, 4Runner dual overhead map light Gentex Auto dim + Compass + Temp, garage,rearview mirror Snow Methonal kit stage 2 Custom 3 core aluminum radiator Linex bed liner Haltech stand alone ECU, Intake supercharger gauge. Stainless steel brake lines, Custom leather wrapped steering wheel, Haltech stand-alone ECU,
    Just go haltech stand-alone with a new wire harness for the sensors if needed and sooo much more power
     
  3. Nov 17, 2022 at 3:35 PM
    #3
    Ironworker84

    Ironworker84 [OP] Well-Known Member

    Joined:
    Nov 4, 2018
    Member:
    #271625
    Messages:
    183
    Gender:
    Male
    First Name:
    Eric
    Vehicle:
    2001 White Tacoma 4X4
    I'm tapped out on funds
     

Products Discussed in

To Top