Colorado B.S. Thread

Wheres @TMFF He may have some suggestions

 

Nah send it. One step closer to cutting it all off. It's already bent one.

 

Probably in the realm of 5300

700. Someday I'd like to get bilstein 81xx series properly tuned. If I remember correctly the only reason I put on 700s is cause all the cool kids were doing it.

Ah yeah I could see that helping. I really should just design a top hat like king has and be done with it. Although it should be physically impossible for the stainless hat to break before the bolt. I could do the smart thing and sell them and get indestructible 5100s

 

I’m running 700# springs and @TMFF suggested 14” 650# springs.
Once mine need to be rebuilt again I’m gonna be done with them. I’m gonna pony up and go with something better.

 

Yep. The 8112s are super appealing.

 

Do it. DOOOO IT!

 

I would definitely find a different dealer. Ive had nothing but problems with that dealer not honoring warranty claims and recalls. Other dealerships I've been to do the work no problems and no questions asked.

 

I've had good experiences at BK tire in dacono, might be worth a call to ask.
Curious why you're against bbs?

 

VVV This.

I won't let them do anything to my truck except mount and balance tires I purchase from Discount Tire. I would not even let them do the Toyota Care work. F'rs rejected my rear center stop light replacement which was broke when it came from the factory - they wanted me to pay them to replace it and I said no. Then they would not even sell me the parts so I could do it myself because they were part of the special recall campaign. BS. I bought the parts on-line and did the work myself. Find another dealer.

 

1/3 of the way into this bumper, and starting to question my life decisions.
That thing is going to be a bear to install with a winch attached.
But otherwise it's going fairly smooth.

 

Engine hoist. Winch + tree saver around the rafters + pulley.

 

A lot of us work for beer and pizza…

 

A lot of us supervise for beer and pizza*

 

Ftfy

 

Huh

 

I need a Tupperware or preferably Rubbermaid container with inside dimensions minimum 4" x 4", but not much bigger than 4.5" x 5.5" outside with a minimum depth of 2.5" but no taller than 6.5" for a solenoid re-box project...
Otherwise I'll just electrical tape the shit out of it and hope for the best.

 

Seems like a standard enough size

 

Close. Might be tight on the short side.

You can't have mine, but you can find them on Etsy https://www.etsy.com/listing/1337282631/vintage-1980s-square-tupperwar

 

.

That could work. I might go raid mom's cupboard tomorrow and see what she has. She might not like it if I call her tupperware "vintage" though. She'll like it even less if she finds out I intend to drill holes in it.