1st Gen Lunchtable Thread - General Discussion

Could just flatbed it if you find a cab. Not sure if you’re into that. I’ve seen people relocate frame body mounts too. The guy that slammed his 5 lug and put a double cab body on it did.

 

My friend actually had one of those on Maui it was really nice, let me see if I can find a pic.

 

Loved that truck, I wish I knew where it was i'd buy it.

 

Fresh double cab manual trans swap then wrecked, man that fucking blows

 

I was thinking the same thing, The trucks paint looks great too I bet it was nice....while it lasted.

 

Still no power. I said fuck it and fired up the gas generator to power the heater and a few other things. Gas for the win!

 

Figured I'd make a quick Home Depot run; need hardware for the latch. Hardware shown is just for mock-up.

Pulled a @Yota X and drilled holes and hit it with a flap disk while in flip flops



By the way, not sure if the sale is still going on but I paid only $1.49 per magnetic dish.

 

@eon_blue

Is your cv axle seal leaking?

 

the axle tube looks greasy so if it is it's just weeping, definitely not bad enough for me to want to fuck with that nonsense again until it gets worse lol

 

Ok cause...I was looking everywhere for my 'stop' for the swingout arm.

Looked through my box of "stuff to install" and I realized I still have your seal driver handle...

 

oooh yeah, well I'll just add it to the list of stuff to do whenever we do the mod day up there

 

Trying to do more shit for my bumper, at least little things for now. Thinking I'll put some time into it this Sunday to get it finished up before mod day.

 

This is more like it for 93 Premium. Used Kroger points and got into 93 octanes at .60 per gallon discount.

Though, there is a Shell down the street that is selling regular at $2.79.



Price before Kroger card discount.

 

I just managed to move that sheet of steel into my garage. Weighs like ~125lbs and it was raining all weekend so I didn't even try messing with it.

 

Oof

Man I hear you! My left over 3/16" is much smaller (5' x 12.5") and I dreaded getting it out from behind all the extra shit I have. Buddy needed multiple 6" x 12" pieces cut.

You just need to make a "mount" so to speak right?

 

This looks fun
'75 Corolla Coupe Rally Car

https://bringatrailer.com/listing/1975-toyota-corolla-5/

 

Want

 

Nice! Fabbin in flips puts hair on your chest.

Scored some more beef today. It calls it’s name to me and I have to listen. Don’t worry. 5 min w the wire brush and it will be pretty. Lol

 

Holy shit that's a lot.

I'll admit, been wanting an anvil as of late.

 

Lol. That is less than half of what I got today. Gotta get that free steel when you can.