What have you done to your Tacoma today? 1st Gen Edition

I'm putting together a list now, still researching. Relatively cheap and will probably just order them and see what is needed and what isn't. 2 of the kits share/duplicate some plug part#s as the kits are based on year range (11-15 & 16-17). While I don't need to do it because of location, still don't mind putting together a list. Someone did something similar in the 2nd Gen section and it'd be nice to have it here in the first. If you do think of anything, please let me know. Thx!

 

I’ll check. Some of these still have bags. I’ll try to take a mental note of which are best

 

Yea… not going to find an easy way to make this work kit wise. I got a lot covered though. All the bottom drainage holes are open. But sides and tops mostly all unused holes are covered.

 

That's a weird looking core support....

 

thats my... uh.. trophy... my tundra had its door folded backwards... because i ignored an issue on it long enough and it bit me in the ass...

 

i call it a night here.. 2 prerunner spindles mounted for roller duties.. need to toss the diff on the left back together to use it for roller duties too. then i can work on getting the truck here and start pulling the transmission and engine. i DO need to get a new clutch (even though the current one is new... the throwout bearing sounds like hell) and i am debating doing the steering rack since im here (and i need a rack for the wrecked 2001 so it can steer again)

 

PM me. Compressor is avail for use

 

Swapped out the fuel pump after 250k on the original. Took about 2 hrs on a double cab. Started by removing the bed only to realize that double cabs need to have the tank dropped anyway. I would still remove the bed if I had to do it again. It made disconnecting/reconnecting the lines much easier.

 

This one's for the manual but yeah. I was suprised also at how cheap it was. Order online. Pickup at your local dealer.

 

Shit, if you need to run any wire down the frame... nows the time haha

 

This trucks going to be a slight resto. It’s a cream puff other than the rust. 94k miles supercharged… but the frames gone. So. It’s staying stockish. But I’ll load it up with TRD goodies as I can find them.

 

Temp axle tossed on. Should have a lot
More stuff tomorrow. Hopefully have the front end ready to roll too

 

How did you get rust on that new frame already?

 

Spindles are off the spare double cab frame. The axles off my dads truck… only rusty bits on it!

 

Shit, I forgot.

 

Sold it for $3000 more than I bought it for.

 

The fun is about to begin

 

LT is something i REALLY want to do.. but i REALLY dont have anywhere to play with it properly. well except silverlake up in Michigan

 

Too bad the LT arms on the green truck were ded