What Have You Done To Your 3rd Gen Today?

That looks really good - I will need to do this in the spring

 

Started off the year strong. Going to put an aluminum oil filter cover on today because the OEM one didn’t play nice with my ugga dugga. Turned on the truck and it took about 5 seconds to empty out.

 

In addition, also clay the windows as it removes a lot of contaminants on the glass surface. I also do a clay - hand swirl remover - hand polish - wax treatment every few years. Makes the vehicles look brand new. I did the new Tacoma when I first got it (clay than wax) and it made a big difference in the smoothness of the paint and the shine.
Adam's products work really well.
https://adamspolishes.com/products/adam-s-fine-grade-clay-bar-detail-spray-kit

 

That's a mess - Do you know what happened?

 

Went ahead and cleaned up the lines on my fender flares and added edge trim.

 

Organized the garage a bit. All fit perfectly with room to spare

 

Something like this works perfectly for hiding the wiring going up to the light in your rack: https://www.kchilites.com/universal-wire-hider-kc-6300.html

 

following for if the air raid snorkel fits with the uptop bravo rack.

 

Finally got around to installing my single ARB Compressor with GTFO Expedition single/double mount. The mount is awesome, direct install without modifications. Definitely attach compressor to mount before installing mount to the truck. Kept the ARB harness with fuse and relay and used the AuxBeam AR-800 as the "switch", (10a bank) . Forgot to get the "T" fitting for the hose and pressure switch, so just have the switched installed temporarily so I could complete the wiring. Plan on plumbing a hose to the back of the truck, either in the bed compartment or opposite the seven-pin trailer plug next to the license plate. My OCD Corrected the orientation of the ARB filter cover after I took the pictures...

 

I see, it looks great.

 

After a slight delay, the rest of my tires showed up along with my wheels. Should be getting them mounted this week.

 

Finished the Clazzios! Rear was much easier!

If you’re thinking of them, do it!

 

Ugh!

 

I watch MORR pretty often, haven’t found my way to that one yet lol. I’ll search for it sounds like an interesting watch

 

Damn, those look really nice!

 

I just ordered the Auxbeam unit and am looking to do an ARB compressor unit later. Do you see any issues with the Auxbeam to power your compressor? Also, what type of mount are you using for the Auxbeam? Thanks

 

Ordered a motorola ma1. $30 off at Best Buys


https://www.bestbuy.com/site/motoro...-black/6505050.p?skuId=6505050&ref=NS&loc=101

 

Mounted the pipe today.

 

Installed the durobumps, hammered back the firewall where I was rubbing, zip tied the bottoms of the plastic fender, rolled on some more bed liner and stuck on a set of tacoma letters.

 

Very nice!