What Have You Done To Your 3rd Gen Today?

Not me but my daughter. She got wheels & tires for xmas, Method 316 with 265 Nitto Terra Grappler G2's. IMO it's a much better look than the SCS Ray10's they replaced. Hate that fake beadlock that are on so many wheels today.

 

Conditioned Clazzios with Lexol. Nice sheen and soft!

 

Yup they are the smoked ambers.

 

After helping people get unstuck this morning I decided to go get myself stuck in the snow instead.
Went to go cross country skiing and the parking lot hadn't been plowed but I figured I could make it through the lot.
Made it about 20 feet in and got stuck, guess I should have just turned around when no one else was there.
Once again I had to get out the traction boards to free myself.
My cheapo X-Bull traction board, that had started to crack, finally split in half
I got maybe 10 recoveries out of the boards over the last 3 years.

So I figured instead of spending another $100 on boards that will break under light use I will go big and order a proper set of MaxTrax MK2 boards.

 

Fired her up, sat in her then said night night. I dont drive el diablo taco innthe winter

 

You have a fair weather only Taco? Incontheivable!

 

That looks fantastic!

Specs on the wheels/tires?

 

I know many would say not to do it, but I’ve used a soft shackle around alloy wheel spokes if the person isn’t stuck badly. When it’s someone stuck in a driveway or hung on a drift, a light pull while their car is in neutral is all you need. Every time I’ve done this, the wheel that’s being used just slides with the pull and doesn’t turn causing any binding. Again, I only do
this when the need a small pull. Other than that, not much else you can use/do. The screw-in tow points aren’t very good for pulling lateral, but are ok when pulling straight on.

 

Finally got everything together for my lift.

OME 885/5100s
Icon rtx pack

Also tuned it with kdmax9.0

Very happy with both

 

The other half of my Goose Gear seat delete arrived today so I installed that and put my new plate on. Yea I didn't obscure it because I ride around all day with it exposed so not real concerned about someone seeing my license plate.

 

https://www.4wheelparts.com/p/goril...it-black-k6cs-12150bgr/_/R-FHMH-K6CS-12150BGR

I picked this set up, they are holding up well. Just rotated the tires, no sign of rust.

 

Slapped on the Ironman 2.5 lift today. Disregard the mess, the add was kickin in real bad this morning.

 

Wheels are ssw summit apex 17x9 -25 offset.
Tires are goodyear wrangler duratrac 295/70r17.
Instantly had rubbing so cutting was needed.

 

Swapped out LEDs on a clazzio heated seat switch. Much better than the bright green it came in. Might throw together a write up on doing it. I've only consumed info from this forum but contributed nothing. Should probably change that.. First post BTW!



Edit: Better picture I had. That color is damn close to stock if I say so myself!

 

Productive day what plate Frame are you running?

 

Thank you!!

 

You're quite welcome!

 

What have I done today? I looked at it, sitting in the driveway being rained on, while thinking, "Why don't I have any place to go?" Maybe I should go look at the MESO site or something and find reasons to tinker?

 

Excited for the wheels to come in!

 

Meso will give you reasons to tinker for sure