Ugly Gold 4 door Hoor SAS-LS

ARB compressor and lights

 

You run the arb off one of the 40 amp relays? Do you by any chance have an ignition, charging or starting diagram?

 

Yes. I have my drawn diagram somewhere.

 

Finally putting new parts on the damn truck again.

-Fuel delivery basically done. Just have to terminate at pump and put filter bracket on.



Got a transom bulkhead for wires. Just gotta add another one to top.

-Tank mounted.

 

How many gal is that

 

Its a temp tank. Im gonna build a nice one flush with the fender wells all the way across. That one is 19 gallon but the truck should like 22+mpg or more once I get low rpm fuel map area to like 15-1.

 

Ratchet straps guarantee it's a permanent install

 

You can always count on a couple of used ratchet straps to get the job done!

 

Why even use a fuel cell when you have a factory tank and one dirty strap?

 

Oh fuck yea! That guy knows what's up! He's got the whole kit. Even the worm driveshaft balancers!

That's how an OG off roader gets down. A 12 pack and a bunch of old parts strapped down to any strong metal available!!

 

It's Smiles Per Gallon

 

Oh. It doesn't look like 19 gallons. Looks pretty small in that picture. Ya should be Gucci with that mpg

 

The "I know I'm crooked" note from the last post is probably my favorite.

 

Hope this turns out ok.

I swear like 4 diff people commented on that plate. 2 who didn’t know shit about cars. So, I wrote that and cleared over it

 

All hot feeds done. Switch next.

 

I see you got that slinky profile pic! looks good!

 

My first resister. Alternator setup. I’m assuming it resists from the switch power side? idk if this is how you even solder them. Lol

 

Stainless is therapeutic, aluminum I have to start drinkin to tackle.

First tube joint. Embarrassingly bad, but gonna buckle down and get it together for the next joint.

This one is definitely getting ground smooth.

 

Embarrassingly bad? shit, I've got a whole bunch of AL for stuff you can come build on my truck with welds that look like that. I'll take that anyday

 

Man. I’m not feelin the Al skills at all. I got a nice tig to roll dimes on anything. Al is gonna be my bitch in 2 weeks.

Did a primeweld heat test. It goes for a while. @Kwikvette the 225 is beast. Did this at 70 amp for like 3 min. Al broke down before I had to stop.



full 4 rod blaze test.