What Have You Done To Your 3rd Gen Today?

That's why I went with the OTT tune so I could choose a level, I went with the mild which is the second step up and if I press ECT it puts me in medium which is great for highways but a little too touchy for me in parking lots and stop and go traffic.

 

Curious if you went galvanized steel or aluminum? I'm leaning towards aluminum even though its not as strong for rust reasons. I've been unable to find stainless.

 

Newest install. Warn front bumper, Warn winch, ADI off-road rear bumper and Diode Dynamic lights going on within the next few days

 

Thanks for the reply. I’m really hoping I can squeezr the wheel/tire setup I want underneath a wescott designs kit until I figure out what actual suspension system I want to go with. I’m not afraid of some trimming, bending, molding, or CMC as long as I don’t have to touch actual body panels. *fingers crossed

 

Thanks, it's the BRAVO from UpTop Overland. I also have the Cali Raised single light bar and it fits very well.

 

That's a great price. COSTCO online has the bumper hitch bundle with hand pump for $250. They have the other WaterPort sizes as well.

 

I need to stop browsing this thread because I think I just found my next purchase. This will come in handy after a beach day. Does the water heat up if you leave it out in the sun?

 

Yeah well i had to cut the inner part of the body panel but it’s in a part you can’t see unless you look under there. Then just painted all the cuts black so it’s more concealed

 

Not too much, but if its out there all day in the sun it will. I use it in the summer time on hot days to spray the kids at the summer camp down the street to keep them cool.

 

Thanks! I'm sure I can find some other uses for it too.

 

Discreet booze dispenser

 

And it has different spray settings depending on choice of beverage

 

actually I just remembered
There was a DIY where a guy made one for $50 to go on his roof rack
Which he added a schrader valve to. To pressurize to a certain PSI with a tire inflator to help spray water

 

I just used steel (12 gauge, I believe). It's under the bed cover and has a coat of rustoleum, so it should be ok on rust, but who knows. Aluminum should be fine as well and easier to play with.

 

Just FYI, there are similar throttle options with the KDMAX tune. Light, normal, and sport. I believe by "stock pedal" he meant he was dropping down to normal or light throttle option.

 

Did you have to get that bed rail mount from the waterport website as well?

 

How'd you wire em? Got pics? Coz you know...

 

yup. I was hesitant at first, but now that I got it, I like how it's completely hidden when the bakflip is down.

 

That looks good. I'd have to mount mine on the drivers side so I'm guessing I'd want the 16ft hose.

Did you use the bed rail mount from their site? How far off the rail does it place it? I have a camper shell on my truck, and it clamps into the bed rails - I probably need it to be about an inch off the rails.