Help with DTRL removal and front turn signals

Hello,

I have an 07 Prerunner that did not come with stock DTRL. I had added DTRL to it a while back, but I just removed the harness. The reason I took em off is because I added LED turn signals to the rear lights so I was getting hyper flash. I ended up getting an LED flasher and my rear turn signals work now, but my fronts are not working. I did some research and read that I needed to remove the DTRL or they won't work. Well I removed them and they are still not working. Any of you have any ideas why?

 

Your TACO is missing the junction block where one of the connectors went.

 

What @caribe makaira said.. You can get the block or there are some aftermarket ones that also give you some extra hazard options and quick blinkers. I removed my DTRL and added that but def need that deal.

They sell one that is for LEDs and one that is for the Smart Tap which I mentioned.

$20 Diode Dynamics LED Flasher compatible with Toyota Tacoma (non-DTRL) 2005-2015, CF18 Standard

Flasher Module

 

Ah without the junction block the Taco has no front turn signals, hence the situation.
Turn/Hazard Relay is to the left of the block on the picture I posted.

 

Hell yeah thank you guys so much

 

Man no one has that junction block in stock.

 

ah I thought it was the one or a version of what I posted for Diode. When I removed my harness I placed it with the smart tap which controlled the hazard and blinkers. Its Amazon you could see if that is what you need and return if not.

I may have mixed up the relay for the junction block.

 

You could assemble a substitute.

You already have the required connector ( from the removed harness)
P.S. wire colors in drawing is for '11+. But of terminals is the same.

 

Here is a pic of my harness. If I'm correct it should the white plug right? And if so do I just cut the wires coming out of and just plug it?

 

Correct

 

Ahh I see. All I did was unplug my harness and add the LED tap. I left the other end of the harness intact and just unplugged it where I replace it with the smart tap.

 

Jumper ties front turns with rears when using plain Haz/Turn relay (Halogen or LED type)
DTRL are controlled by the other type of DRL/Haz/Turn relay, hence no "jumper"(junction block)

 

So just added the plug from the harness and still no luck

 

See post #9

 

I sent you a message

 

https://www.corsa-technic.com/item.php?item_id=1064



Looking into the connector identify locking clip, use tiny flat screwdriver or needle tip. (for de-pinning) pay attention to terminal position at removal so the added terminals go in at same "direction".