1st Gen Lunchtable Thread - General Discussion

Deer getting high on nitrous emitted from decomposing leaf pile is pretty funny

https://www.youtube.com/watch?v=QAOqgZKa8Ck&t=170s

 

Abraham yancer

 

needed that 3lb mallet instead. 6/10

 

morning LT crew. Any reason lift shackles for 6 lug wont fit my truck? IIRC it will work, thanks!!

$94 Maxtrac Suspension (716920) 2" Rear Lift Shackle for Toyota Tacoma

https://www.amazon.com/Maxtrac-Suspension-716920-Shackle-Toyota/dp/B00D3XVPI2

 

Might never break 45mph but you'll never break down

 

@Speedytech7 @jubei did you cut the rear most front fender mount off when you tubbed?

Trying to decide what I want to do to fix it. Might run a bracket off the lower door hinge idk

 

Milwaukee sure is a cult lol



I was looking up cord grips, apparently elechickens get cold easily

 

That also could very well for my Amish name

 

A swing and amish

 

https://music.youtube.com/watch?v=peQhtPQ2Kzk&feature=share

 

https://music.youtube.com/watch?v=eDDx3AWX81s&feature=share

 

https://music.youtube.com/watch?v=2uJWSWw7XA0&feature=share

 

The one at the bottom? No I left both of them, but I nearly cut the forward one in half, just barely left enough to thread a bolt into it.

 

Yeah, I didn’t end up with much more than an inch of fender down there and the OG mounting locations were long gone. For at least a month I or two, I literally ran a small piece of duct tape to keep the fender from flapping around

Eventually, I stacked tacks around a flange nut on the body side and drilled a hole in the fender that lined up with the nut so I could actually bolt it down. It’s held ever since. The nut was better than a rivnut because the nut stood off from the body just enough to make the body lines not look funky. Not that any of it looks great anyway

 

hehe that sounds perfect, I should dump out my spare hardware and see if I could do similar. I have had the bottom most fender hole zip tied to the cab mounts to keep it from flapping in the wind too much but it still rattles quite a bit

 

Mine is entirely bolted down as it should be but they're fiberglass so it needs the tension from the bolt to stay in the right shape. I didn't have to cut quite as much of them since they don't contact the tire the way a stock fender would.

 

Just be warned, those things dont provide nearly the lift they say they do. I had a set of those, I think they gave me like half of whatever they said they would. Sold em and went with a better leaf pack.

 

Yuppp. Whatever the length increase from the shackle is you get half of as the lift lol

 

Pretty sure they'll fit just fine, you might find that they prematurely wear your leafs out and make the ride firmer though

 

Ahhh yeah you a fancy boi

How did the paint turn out??