What Have You Done To Your 3rd Gen Today?

Yes, the parts list is the black versions of the dash surround, door switch panel, and the center console trim pieces.

 

I made a short road trip north to pick up/install my RCI sliders. The folks at @RCI-Offroad were super nice and I think the sliders (5 degrees, no top plate) look rather handsome on my truck! Total build time was about 5 weeks. 22 mpg round trip.

 

I would say disconnect positive terminal or you could still be shocked if you ground a wire on something by accident. I usually don’t disconnect anything though because Im lazy. Except for welding or plasma cutting on the frame

 

honestly, if you're questioning it, don't do it and/or pay someone else to make your problems their problems.

 

Looks good!! Let's see the whole enchilada !

 

I have the tailgate done too but I have no idea how to block my plate..lol.

 

Installed the Alpha Rex tail light and also Thule Approach RTT

 

Another front shot. Terrible with this posting stuff.

 

Nice. Thanks for the extra pic of that fine job. Did you do the work, or did you hire out the wrap install?

 

I was tempted but luckily I have a great shop 2 miles from my house cutting around the PRO decal was my worry. I let them do it. Here’s the tailgate.

 

I thought about an Ironman set up for a while on my AG. How do you like it so far?

 

Tailgate looks great too! I just noticed you're on message #10, so welcome !

 

Installed H9 bulbs in the low beam. Should have done this years ago.

 

Yanked out this fellow door dasher who took the wrong turn after delivering food to the homeowner. It was a big property and this was their horse corral area.

 

They probably used this:

$30 3M KTS-DL1 Design Line Knifeless Tape - 50m (164ft)

https://www.amazon.com/dp/B00IJJ3SG2

 

What was the attachment point on the Dasher's car?

 

For ramps? Check out this post:

 

rear subframe

 

How or where to get Amber bed lights?

 

You're a good human, making someone's day not so bad as they thought.