What Have You Done To Your 3rd Gen Today?

I like these silicone bands, for manly grip.

 

No pictures…. But I removed the air dam.

 

Details please. This looks awesome! Thanks.

 

Added a set of SS3 Pro Ditch Lights in driving pattern, already had one SSC1 Pro on each side.

 

I bet that looks pretty sweet at night

 

just replace my intermittent failing HIDs to LED. what getting pissed at only 1 low beam working until i switched the light on and off for like 10 minutes.
got them i went for the Fahren Termitor they had decent output in projector and were comparable some Hikari 2023. the only bad thing is that now the blueish HID in the fogs does not match the white LED.

 

You could always go to Amber fogs. Easier than trying to match the right white on the LEDS if you got a touch of the OCD.

 

Doesn't suck

 

I installed a 2" lift in the front, and 1.5" Add a Leaf Lift Springs in the rear and then installed 285/70/R17 Cooper Rugged Treks and Method 705 Bead Grip Wheels.

We loaded up with gear, and towed our 14ft Lund Boat 2.5 hours away putting about 350 miles on the new setup and got 16 MPG after calculating the extra 4 miles driven for every 60 on the odometer. I was able to get 280 miles on a full tank of fuel and only had to put 17.5 gallons in to fill it back up. The truck's computer thought I was only getting 14 MPG's.

Took the boat for a nice day on Lake Roosevelt in Washington to test out the 4WD capabilities of the new setup.

 

I love the flatbed, it was a game changer when i went to this set up over my regular canopy and truck bed

 

where did ya get the bands?

 

Installed TC bed stiffeners, instal was nice and smooth.

 

I plan on doing this once I get a camper.

 

I just got the speedometer recalibration thing from rough country that fixes the speed, mileage, and mpg for bigger tires and it seems to be working nicely. Haven’t been on any long trips so not sure of my mpg with new tires.

 

Did the LED interior light replacement off

$19 AUTOGINE Super Bright 6000K White LED Interior Light Kit Package for 2016 2017 2018 2019 2020 2021 2022 Toyota Tacoma + Install Tool

Amazon

All the videos did a good job at explaining how to install most of the bulbs. One video said to remove the overhead light from the rear. Don't do that, the rear of the light has a bevel that the clear plastic goes into. The front of the clear plastic and house where the switch is located has small areas for a prying tool provided.

Hope this helps someone.






The image below, you can see the bevel at the rear of the light that the. It makes it very difficult to get the plastic pry tool in there. The front where the switch is located also shows no bevel.

 

Got a free water rotopax so I upgraded my gasoline mount to a locking one and added a Sherpa mount to mount the water next to it! I also have a dust cover/shield coming in the mail that I’m planning to retrofit onto the lock on the rotopax mount so water doesn’t get inside and mess it up

 

I thought the steel wheels took a different TPMS sensor than the aluminum?

 

Installed my new Wish dot com MaxTrax. Not really sure what the hype is though, I don't see how these help at all

 

You’re going to need the straps on those or you’re going to lose them in the mud!