FS: Eibach 1” lift blocks

Perfect condition. All hardware included.

$75 shipped.

 

Used or new?

 

Installed, then taken off. Never driven on. A little too much rake for the canopy correction I was hoping to achieve. Ordered factory trd pro blocks which are 1/2 inch.

 

Bump- discounted to $75

 

I’ll take them. Pm sent

 

Sale pending

 

Is this photo showing what the block looks like installed or before correction?

I have a Leer 100xr on the way.

 

Blocks are sold.

 

Before install. Bed is quite loaded in this photo, but you can see some rear sag for sure. I ordered 1/2 blocks from the trd pro that I’ll install in the coming weeks.

 

Edit: Nevermind, read the specs on the Eibach site.

Did these 1" blocks lift it 1" or 2" (usually its 1:2 ratio for front lifts, so I don't know about rears).

I'm planning to install the archive garage AAL that nets 2" unloaded and 1" if you have 500 lbs over the rear axle. Then I plan to do 1-1.25" lift in the front. I think it'd look decent w/ a topper's dry weight. I'm guessing i'd get about 1.5" unloaded in the back.