What Have You Done To Your 3rd Gen Today?

nice fit, even from a 6ft bed to a 5ft

 

Here are pics of the RCI 5 degree sliders on my truck: https://www.tacomaworld.com/threads...3rd-gen-today.399305/page-12619#post-28282174

 

RCI 20 degree on my old truck I just sold. I am putting them on Solaris now.

 

Good luck with the install. Let me know how that goes.

 

You do the bottom bolt first. Once it's in, the sliderholds its self in place. I used a floor jack with a 2x6 on top. Place the slider over the 2x6 and strap it on with a bungy cord. But honestly having a buddy hold it while you put in that first bottom bolt is easier.

 

I was going to go that route but just decided to do the spacer. Wasn't sure if having them on two different settings would change how it handled bumps from side to side. Plus I was about 5/8" lower on the driver's side, so I figured the spacer would get me a little higher. Im sure it would be fine to do though, just depends on how much lean you have.

 

I did the spacer to compensate for the Taco lean on the drivers side as well. I think it was the right decision.

 

jk, doesn't look too bad

 

Thank you for the timely info/reminder. I remember you saying this once before here on the forum!!! The 2x6 was the additional info I didn't remember....

 

Finally time for the first oil change on my SR5 that I bought last September and replaced the plastic oil filter housing with a metal one.

 

I just added Bilstein's to all four corners as well. 4th notch in the front (1.5inch). Ride is super smooth and planted with 265s.

 

Looks Great!

I'll be doing the switch on my next oil change in May.

 

Looks legit to me.

Mine is authentic TRD shift knob too.

 

Wait a minute! lol

https://www.tacomaworld.com/threads/cheap-mods-that-you-are-proud-of.786170/

I recognize that gear selector...it's the one I took off and replaced with:

 

Westcott sliders. Placed the order not expecting to hear from them for weeks. They called me the next morning and said they had those specs in stock. Picked them up and installed less than 24 hours after making the order. Great group of guys when I went up. Threw em in the bed and explained how to install.

 

WHERE DID YOU GET THIS?

 

That is a tight looking front end. What bumper is that?

 

It’s the aluminum stump bumper from Greenlane off-road

 

Got my DS18 tweeters installed today. Super easy and went fast. Sound difference is quite noticeable and I’m not an audiophile. Not sure what to set my treble, mid, and bass at now though.

 

2020+ TRD Pro tail lights.