1st Gen Lunchtable Thread - General Discussion

damn boiii you had a busy day, how'd you carry all that out?

I'd have to check the flanges are the same on both ends but I could probably use the halves to make a square tube spare if so

 

Oh Lord lol i need a personal project manager

I just remembered i never ordered an fittings for my steering res

 

They've got some pretty sweet wagons in this yard, rolling on the finest spare tires available.

Unfortunately since the engine in this truck was already gone I didn't get the part I wanted most... the "mini header" exhaust manifold.

 

Hmm…

 

Maybe you need spares if we gonna actually wheel this year

 

Haven't run MSV or telephone hill in 6-7? Years lol

 

https://music.youtube.com/watch?v=fqQNRwJkkXE&feature=share

 

The entire state of CO would be on fire in less than 30 seconds

https://www.instagram.com/reel/Cn44Rvrjys0/

 

So, you should only roll out your Baguettes to 18" if you have the appropriately sized pan.

Doing an experiment here; kept 2 of them at 14oz but they're now "fat" cause I folded the dough over to fit my smaller pan.

The 3rd one I chopped the excess off to keep it the same density as if it were a longer loaf.



I'm not one to really use steam and instead I egg wash my stuff.

 

Anyone here want like $100 worth of leftover Costco sandwich platter

 

10 minutes in, turn. And I lied, I still opted to use steam.



You'll notice the middle one (and farther one back) are the 2 at 14oz. The close one is really how dense it's supposed to be had my pan been able to accommodate an 18" long baguette.

 

Do you guys know about Solidifi3D products?
Compartment for the rear of a 4Runner.

 

Called it; by maintaining that lower density the loaf bakes perfectly



The other 2 were a little less predictable



You want to quickly depan after removing from the oven then place on a cooling rack to allow that crispy exterior to form

Leaving on a pan causes carryover and will leave you with soggy bottoms

 

Links are better

 

@Wulf

Your DIY exhaust manifold if you owned a Honda

 

It is certain

 

Code 3 MX7000. Good workhorse. Draws a TON of amps. My MX7000 draws 45 amps at full load.

 

Stuck.

Yokies suck

 

That color

 

Yeah it's the best 01-04 color. Also, I'm a hundred miles from home and I thing that my rear axle bolts are loose