1st Gen Lunchtable Thread - General Discussion

right now, i drained it. but water for a first start and flush.

 

Coming from your air compressor/regulator you don't want or need more than 90psi. Pretty sure that's the max.

From there, it's just pulling up on the front rotary knob on the machine to adjust the air pressure for your torch. Flip the switch to SET AIR and you'll have air coming out the torch to allow you to adjust to your desired air pressure shown on your machine.

 

I didn't get much crud aside from what looked like tainted distilled water when I 'washed out' the radiator.

 

My man's in freezing weather with a freshly fired up project, those often have water only in them so if you have to drain it you don't waste expensive coolant. But water freezes and cracks blocks in shit weather like he's having.

 

Well fuck me, one factor I didn't even consider

 

With some of the panel work we get you can tell they just cranked the feed way up cause the holes look worse than that. I get the desire for cutting prosuction time, but I usually just run the appropriate sized bit thru the oblong hole to clean it up and call it good.

 

Yeah, I can definitely just 'clean it up' and I do intend to do so as mentioned earlier.

I'm using the holes as a 'means of learning' so I can apply it to more intricate stuff that requires fine detail. If I can perfect getting a small hole done on a small bracket or mount, I'll know how to dial in the machine properly for letters, shapes, and whatever small details that require smooth lines.

 

@Wulf
https://youtu.be/6zXkN-I14IY

 

Getting all dialed in for when I send you intercooler brackets, good man

 

@Abeyancer

Used HONDA ACTY TRUCK 1997 CFJ7822091 in good condition for sale (carfromjapan.com)

 

You should know me by now; I don't like providing work unless I got it down to the professional level.

 

I did a cardboard mockup of the piping, this shit is gonna be compact so brackets are gonna be essential haha

 

Send that file over and let's get it cut

 

Bout a month and we will be there. I'll make em by hand first to get tuning and then il draw em pretty in SOLIDWORKS and send em... Think you can do aluminum?

 

SEt the smoke alarms off and scared the shit out of my sleeping kid. So, gonna be an outdoor thing w out some type of tray w water. works really nice though.

 

You'll be the only aluminum request so...I'll find you the cheapest aluminum sheet I can?

 

Lol you'll want ventilation for sure.

Even then I don't recall much smoke at all? What were you cutting exactly and how thick?

 

I'm sure everything can be made out of a 1'x1' square of 1/8" 6061. All gonna be little brackets

 

It's an A.I. thing

 

lol
5/8