XTP Intake Manifold Spacers (IMS) Group Buy Gen2!

XTP (extreme truck performance) Intake manifold spacers (IMS) for sale. Includes Gasket, Longer bolts and Washers. The XTP IMS has been CNC machined from 6061 Billet Aluminum and comes in assorted anodized colors, Blue, Black, Billet Silver, Fast Gold and Fast Red.
GROUP BUY Discount! You can use the link below to navigate to the website and use the very bottom shopping option on the Toyota tab. It should say Group Buy. The one key to this discount is that it will take a little bit for inventory as this will get the CNC shop to run an order. All orders that come in will get placed in the order that they come and I will post below so people can see how it's going.

100% Positive Feedback!

https://extremetruckperformance.com/

With this spacer the mid-range to low-end power and torque increases. There are top end gains as well, but not as significant as the lower rpm range of about 2500-4500 where midsize vehicles can use this additional power since they are not constantly running high speeds. There are many reasons why adding more power and torque to your midsized vehicle is beneficial. If you are towing trailers, driving at high altitudes, adding lots of heavy equipment to your vehicle such as aftermarket bumpers, winches and heavy roof racks, running oversized tires, or you just need that extra ‘pickup’ to get you up to speed on the highway or you are just looking to get the most out of your engine. This spacer can also improve mpg due to the fact that less throttle is now being applied in order to reach the same desired power output,but you must drive diligently to begin with.

1.JR - paid
2.BC - paid
3.EM - paid
4.SG - paid
5.JP - paid
6.WD - paid
7.AB - paid
8.CT - paid
9.CS - paid
10.TS - paid
11.ST - paid
12.EF - paid
13.KH - paid
14.JD - paid
15.JC - paid
16.AG - paid
17.CE - paid
18.

 

Link did not work for me.

 

Try it now,should be good

 

Doesn't work for me either.

 

I turned off VPN and it worked for me.

 

I've had sites do that from mobile VPN too.

 

Still need a few more!

 

Link not working for me....

 

Just worked for me

this is the og op with tons of info

https://www.tacomaworld.com/threads/xtp-intake-manifold-spacer-4-0l.297774/

 

https://extremetruckperformance.com/collections/toyota

It should work fine I'm on a mobile phone. I stated above, if you have a VPN on your phone turn it off and try it again and I'm able to access it myself. You can also go online on a computer.

 

@highaltitude , thank you....I was finally able to get on. Order was just put through.

 

Ordered.

 

Excellent! Sent all you guys who've ordered so far an email with the PDF for the installation. So if you haven't seen it check your spam or trash.

 

Just bought one. Hope it's worth it!

 

Would this work on the dual VVT-i version of the V6?

 

Unfortunately it does not. The dual VVT-i engine uses a different intake manifold.

 

That is correct, if that's the higher 270+ horsepower engine like a 4Runner then the intake manifold ports were enlarged as part of the improvements Toyota did over the 236hp engine. Unfortunately it won't line up right and work.

 

Sub’d. I’ve been wanting one of these.

Edit: ordered and paid.

 

how many minimum member to join for this company to start to produce this spacer?