New England Mod & Meetup Renaissance group

I keep putting off going to the range. I've got two pistols to shoot that ive never fired

 

It’s a great sport.

 

Thanks everybody for the great advice on the rear shocks to buy

 

Very nice shooting sir. There is a range about 10 minutes away from my house that I took @AllTacosFloat to maybe we can arrange a range day this summer?

 

I'm in

 

I'm in!

Such a good time!

 

Sounds great ! Although, I’m not sure about traveling from Connecticut into Massachusetts with a firearm.

I am a member of a rod and gun club. I can have up to two guests, at time. The club's range is an option, although the group would have to be small. The range is in Griswold, CT.

 

If you have a range where they accept visitors under your membership, I have my out of state CT license as well......let me know

 

Yes, I can have up to two visitors at a time. I would be happy to host. And, there is no fee. Eastern CT, in the town of Griswold.

 

Do not, under any circumstances travel from a state other than Massachusetts into Massachusetts unless it is for an officially organized shoot, and then make sure that you are aware of the storage and transportation regulations.
A simple fender bender with a piece of spent brass in the floor board, if you don't have a Massachusetts license can make you a felon.

 

Absolutely correct. This is actually one of the main reasons why I got my Out of State CT license (not just so I can purchase ammo From Target Action Sports or Cabelas) but also because I live very close to the border and you never know when you might need to cross the border from state to state in any way.

 

Y'all could come up this way...constitutional carry FTW.

 

Wilbraham easy for renewal? I’m due in the next 6 months. Never had an issue in Belchertown of course.

I should really get the CT license too knowing I’m in Wilbraham for a long while at least.

 

I wish that would solve my issue..

 

@AllTacosFloat @Brownmatthall did either of you grab the balance beads by chance? Or did we need to go with stick on weights?

 

I did not. Texting Matt now

 

Not yet, just checked around and some jeepers are saying bb's or airsoft pellets do the same... and I might need a specific valve stem? Think im just gonna pick up some bb's from Walmart and send it when we do this lol

 

Just be careful with those - have seen the glass (?) ones shred a bit and get stuck in the valve when they were airing down. Or up? Whatever it was.

 

I’ve got BBs if you want to use those, plastic standard size ones.
On that note, what was the weight to bead ratio we need? I know I have enough, but just want to double check if we need to measure stuff out.

Good to know.