What Have You Done To Your 3rd Gen Today?

10 minute job...changed out a dying LED driver on the passenger headlight...it wasn't completely dead but the LED was emitting a weak light. Got nearly 5 years out of it so I'm not complaining. Same LED lamp with a new driver.

 

Debadging was the first thing I did when I got the new to me truck. Doors, tailgate, and TRDOR bed stickers. It looks so much cleaner!

 

Clazzio

 

I’m not big on emblems and stickers. But the only vehicle I could find in my desired trim, options, and color already had the blackout package. Hard to remove stuff I just spent a couple benji‘s on a few months ago. So I think just then TuRD stickers will go and possibly the V6. I’ll keep the side Tacoma’s.

 

Nice! That's a very rare configuration. I'm going to assume there are less than 2,000 Barcelona Red TRD Pro Tacomas. Most were automatics so this is a unicorn

 

Finally did my H11 to H9 conversation. I am looking forward to the first night drive with them to see the difference.

 

You're gonna be pleased.

It was the final mod I needed to make for my headlights. I messed around for 2.5 years trying to find a better solution to lighting on the cheap and this was it

 

In an effort to give the dog as much room in the back seat as possible, managed to get a Hooke road overhead panel to fit.

 

Buddy gave me his 23 off-road grill so I can put it on my 17 offroad

 

New SCS Stealth 6 wheels:

 

Chalk-bag cup holder mod for diver & passenger. Excuse the dirty truck

 

I did the same a couple years ago and I'm still stoked. Good call.

 

Finished modifying the rear of my access cab for storage/dog platform.

Used a 1/4" sheet of plywood, cut it up a bit and added automotive carpet from O'Reilly's.

I had previously done the DeWalt toolboxes and Foam mat to make a flat surface so I kept that and just added the plywood on top.

 

Temporarily wired up backlights on my ss3 fogs, while waiting for the plug n play wiring arrives.

 

Leer 100XR installed today.

 

Put on my contour canopy!

 

i just installed my DMM as well and want to hood my power cables. Where are you running your cables for power source?

 

I used a fuse tap into the fuse panel inside the truck. I had the center console up for another project so I ran the ground under that. I didn’t want to tap any wires but considered using the cigarette lighter wires if I decided to tap a wire. Was also going to run a phone cord behind the head unit but figured the versatility of just having a USB would serve me better.

 

Washed it. On the advice of the guy that detailed my truck, I used Absolute rinseless wash... amazing results. I've tried various products in the past, always got a hazy finish, water spots, etc. Nothing but shine with the Absolute, and no rinsing!

 

Added a Gunner kennel (Large) and the Yakima Overhaul with a Skybox and Reeldeal to the mix. Ready for peak winter steelhead season.