1st Gen Lunchtable Thread - General Discussion

Has to be a 2nd gen hummer

 

V8 4x4 4 runner with a hole in the block $1700 somewhere on Georgia

 

https://www.instagram.com/reel/Cn9p98vgjW8/?igshid=YmMyMTA2M2Y=

 

I’m protected by viper.

 

Natural ICE is the perfect beer

Anything Lite but Miller sucks

 

@Tour991

This just got here

 

Coors

 

For like $1.15 each 12ozer it ain't bad at all

The 15 pack was only like 16/17 bucks

 

Must have! My kid slept like a rock but my sisters kid used to get up and bang on the door til she eventually fell asleep on ground by door and her son was a diaper picasso a few times a week. Nice to see this unfold so you can stay on top of it. lol

 

Nice is that the one with the sock?

We did this one.


This is how I set it up.
How are you doing yours?

 

You can buy a sock, but that's another $300

Just raising the mattress height (should've done that long ago) to properly set the camera distance from the wall.

The sage color blends in the best for this background

 

@Kwikvette @Speedytech7

I'm still having to clean these up quite a bit after the chop saw (this is one of the better ones). Should I increase my pressure to reduce time built building heat? I'm worried about dulling the blade or chipping it..

 

What kind of blade is in your saw? I've always used carbide tipped ones and gone pretty light on the pressure for thin wall

 

The one that came with it. Not sure if it's carbide tipped but I would assume so. 14" evolution

 

The evo saws don't cut 16g material or less even. Ive tried a few diff blades. Unless @Kwikvette has found a technique for that.

 

I'm not sure what the thinnest wall I've used it on is. But I've used it on a lot of aluminum intercooler piping and thin wall exhaust tubing without any issue