1st Gen Lunchtable Thread - General Discussion

If I wanted, I could just "roll on" black paint to fix the black painted surfaces as I put tape on it all to paint the insides.

Didn't let it dry before taping it up.



IDGAF though so it's going on the wall as is

 

I need two sets. @Kwikvette can call it the Lunchtable Long Travel Kit.

 

@Abeyancer just got a job interview at Sunbelt Controls. Hopefully if all goes well ill start doing building automation

 

I really need to learn Solidworks, and I mean learning how to configure the Parts and Assembly files in order to fully recreate the setup as it sits.

I'd still need a tube bender, brake press, and possibly a tube notcher until I can fully recreate this kit on my own table (if we're including the upper control arms).

 

I vaguely remember the discussion about this kit. Finally found the thread I was thinking about.

Did that guy just design a LT kit for himself, sell the truck, and get bored? Not much info in his sale thread.

 

This is not the same kit I was thinking it was

 

This By the guy that rebuilds my shocks n shit

https://instagram.com/miles.less.traveled?igshid=YmMyMTA2M2Y=

 

Gotta admit, my pullout game isn't as strong as I'd hoped, gave up 80% of the way. Tomorrow or Friday I'll pull it out.

 

He fully designed it and ran it for years, think he sold a few locally from what I gathered (in PM's and speaking in person).

But yeah, it's everything.

Fabricating one off shit is one thing as it takes forever getting measurements, etc.

Having a jig where everything falls into place and just needing to get welded is so much easier.

 

Yep, seen that kit.

In fact Zane and I discussed both that one and the one I've got files for in length.

 

It might be sacrilege but the 4runner guys kit seems better from a technical standpoint

 

Could blame most of that on the fact that it's been thought out recently, and revised a few times. Could've taken some notes from already produced kits.

The kit I've got files and a jig for is over 8 years old already.

 

I like the 4R guy cause he didn't charge anyone for his shit and he's a good guy anyway

 

Looks like Quick may end up in Vegas.

 

Ugh yeah I saw that too, the world is upside down I tell you

 

I know what you mean. Also maybe they are feeling bad about what they did to Mark Andre Fleury 2 years ago.

 

Installed a wheel bearing on the 4 runner... first one I remember doing where I don't forget a step

 

Step 1 press in bearing, step two press in hub, step three fuck you forgot step 1.5 bolt on brake shield