Tacoma wiring harness connectors

So I’m rebuilding a 1999 2wd extra cab and was planning on doing a turbo and with that comes a standalone. I wanna go all out and just redo the harness but I’m having trouble finding the connectors for all the sensors and accessories Ive looked at waytec but there website isn’t too helpful was hoping one of you guys out there had any experience with this issue

 

Welcome to the forum !

Thing is Toyota used a few vendors over the years.

Are you talking the plastic plugs or the male and female pins to repin the plugs

The plastic plugs should all have the last 5 numbers on the plug .The first 5 numbers are 90980.

I know you can buy crimped pins from Toyota but I don`t have that book handy for part numbers.

Good Luck with the Turbo Charger that tends to get expensive.

 

Thank you that’s good info and ya I’m already pretty deep on expenses and the engine isn’t even assembled yet lol

 

Thank you that’s good info and ya I’m already pretty deep on expenses and the engine isn’t even assembled yet

 

I'm looking for info on the male / female pins to repin a couple of plugs. Are these standard for 2nd gen tacomas (for fog light switch, traction control)?

 

Not always.
If you can get the connector # you can use the manual linked below to find the correct pins.
https://www.toyota-tech.eu/wire_harness_rm/RM06H0E.pdf

 

Thanks TnShooter - that's one super helpful guide. I've already found the part numbers

 

Thank You Sir! i am going to printout another hard copy!