What Have You Done To Your 3rd Gen Today?

Research here.
https://www.tacomaworld.com/threads...-with-courtesy-mode-by-dsim-solutions.709490/

 

Picked up my new boat today. Its a 8 foot pond prowler. Fits like a glove in the bed of my truck.

 

Awesome! Looks a little cold to go fishing though.

 

Yup! Bumpershellz of Cali Raised. Decently cheap quick fix until I can order high clearance bumper.

 

Put Form Lights on my 2023 TRD OFF-Road a week ago..anyone else have issues with the start up sequence not working? Their engineering team is looking into it but they said it would be a few days.

 

Yeah, ice season is pretty much done, so I am switching over to open water prep. Plus cabelas had $100 off sale on these boats so I showed up before they opened to grab one.

 

Mine worked good right after install. Tell them to send you another set. The problem has to be inside the tail light. Or if your foot was on the brake it might cancel out the start up sequence. Not sure

 

Thinking about putting these on my bed rack

 

I installed these on my BillieBars.

$12 True Mods 2pc Black Boat Trailer LED License Plate Lights [DOT FMVSS 108] [SAE L] [Surface Mount] [Waterproof] [12V DC] Universal Courtesy Step Tag Lamp for Auto Work Utility Flatbed Semi Truck RV

https://www.amazon.com/LED-Certifie...x=2pcs+led+license+plate+light,aps,191&sr=8-8

 

Recommendations on the best place to mount the SunPass transponder? Is it okay to put it on that tint mesh?

 

I put mine on the passenger side right below the mesh. The rear view mirror blocks most of my view of it.

 

Thanks! I tried it with multiple light settings and auto-start. Nothing. Might just have to be replaced.

 

I did the DSIM module as well. The only problems that I have had were my fault. I had a grounding issue and a couple of the lights occasionally fail due to moisture. They are cheap and it doesn't take long to replace them. I will use silicone on the next one that fails to see if that will extend their life. I installed 8 lights total. 2 in the front bumper area, 2 under the front doors, 2 under the rear doors and 2 under each side of the back bumper. I have replaced 3 of them so far.

 

What I like about the DSIM module is that it is completely reversible, no splicing or modifying factory wiring.

 

https://www.tacomaworld.com/threads...-with-courtesy-mode-by-dsim-solutions.709490/

$20 Oznium Fade-in Fade-Out LED Dimmer, 2 Amp Current Rating

https://www.amazon.com/Oznium-Fade-...d=1678389422&sprefix=led+fader,aps,217&sr=8-2

 

Thanks bud, I'll have to shake your hand thanks at the coffee meet up at Timmy's when is that next month? I should be back in Toronto by then.
I'm pretty sure we've met before at the one a couple years ago.

 

NP.
Most likely have met briefly. If that pick was last spring is was DAMN cold. Hope the 1st meet this spring is not like that.

 

Will I get rub or should I just trim my bumper and be done with it

 

I mounted my ezpass on the passenger side top corner of the window on both my cars. No issues with any ezpass toll or Florida tolls when we were down there for Disney.

 

Jason (@Speed Freek) did my CMC and some other basic maintenance. Can’t say enough good things about his work!