1st Gen Lunchtable Thread - General Discussion

I can dig it! Priced too high for my blood... and I still get so irrationally irate over people who do up the inside of these vans with shiplap (is that technically shiplap?)

It's soo much extra unnecessary weight for an aesthetic that barely belongs in off grid cabins lol

 

I was just joking the other day about how shiplap makes people think a generic fleet van is worth $100k.

 

I just heard a dialup tone over the phone for the first time ever

 

It really does! I blame pintrest

 

And shock mounts

 

I'm shocked

My spirits are dampened

 

you'll bounce back

 

They will definitely not lift you up.

 

https://youtu.be/Uz7FdvuVjB8?t=108

 

Ftfy

 

I'm sure they will be fine. Not hard to replace the o-rings, screens, and pintle caps. I usually service my own on Nissans. I haven't had the need to do a Toyota yet. You all know about my counterfeit injector fiasco.

I found a servicer in FL that would test for some price like $7 each. The test solution is the same as the cleaner.

When I retire I should open up a service and tout some secret Moonshine Runner special formula.

But if anybody knew the truth about my location, wine was the homemade beverage of choice around Little Italy.

 

What do you think thacuaches were doing in 1996?

 

Someone was saying something about money laundering

 

How often you cutting 1/4"?

When I get home, I'll show you some of my pieces. I've got a few already cut for "future orders" since he mainly does LS swaps.

I do get a bevel but it has more to do with the slats sitting in my waterbed not being "perfect" not to mention I need to square up the gantry tube again.

It was bad about a week ago when one side didn't cut all the way through.

Come to find out, my "programmed" cut height was off by .0865" from my "actual" cut height. Found this out by starting a cut, pausing when the torch adjusted itself just before the cut, and measured the distance between the tip and the work area with feeler gauges.

From there I adjusted the cut and pierce height in my post process and since then, everything cuts just fine.

 

I know well enough to leaf this alone, you'll bounce back

 

That's nice, but is it (MINT)?

https://pueblo.craigslist.org/cto/d/pueblo-mint-2002-honda-civic-ex-sedan/7591039730.html

 

No, they're just fine as far as injectors go. They're quite stable in the other build with them. I just don't like the idea of paying $500 for injectors from the 90s

 

In other news you can marry in west virgina without parents consent at 16 years old but not file for divorce till you're 18

 

Nice! Those injectors are very similar to what I put in the Saab.

Is the deadtime something important to know for the Haltech tuning? Perhaps I can set up something to measure mine?