OBD Fusion tips and tricks

Parameter ID.
Try to connect Fusion to the vehicle. then check Networks again

 

That’s what I use, no issues.

 

I just reconnected to vehicle. I know Im connected because I can see temp and battery status. What do you mean by check networks.

 

Under Vehicle Editor
If not, try to reinstall Fusion and configure it as your old one.
Most likely you need to buy year specific PIDs

 

Success. I reinstalled Fusion and they are there. Thank you guys very much.

What's Temp 1 and temp 2?

 

Temp 1 is pan.
Temp 2 is torque converter

 

Thank you.

 

Attached Torque Converter locking status and Slu solenoid

 

I thought is was Pelvic Inflammatory Diesease.

 

I gotta figure that out. I'd like to add that behind gear status. Here's where I'm at so far.



I pulled the travel trailer for the first time this weekend and I felt naked not knowing the trans temp going up a hill. I'm very grateful to have this took working. Dry weight is 3400 and likely 4000 or so loaded up.... we're light packers.

 

Good job on fixing the saggy rear.

 

OK, I found SLU and locking status. I'd like to create an indicator behind the gear status that shows green when locked and red when unlocked.

What is Slu solenoid?

 

Cotrols torque converter clutch (0/1)
If off(0), torque converter temp will go up fast.

 

So, "1" is locked and "0" is unlocked.

How does "Solonoid SLU" differ from the "Lock Up Status"? It doesn't seem like I would need both to monitor when the converter is locked.... right?

 

Thanks. The Camco R3 along with 3AAL did the trick.

 

You're very welcome. There is a great deal of information in there. Have fun exploring.

 

You need to setup a radial gauge with ranges:0-1. Set the colors appropriately. It’s a little tricky.

 

I'm getting this figured out.

Engine oil, Coolant, A/T 1(Pan), A/T 2 (T/C), Speed and Altitude all seem to work good. But I'm having issues with the following:
1. Gear status Always shows "0", I've removed and installed it and still get same result.
2. Lock Up Status shows black back ground a lot of the time but does show green some and red some. Here's screen shots for Lock Up Status is someone sees something wrong:

 

Am I missing something or is the android version fisher price feature quality compared to the apple version?

 

For the gear you need the “status of the shift status” PID