What Have You Done To Your 3rd Gen Today?

it dont stick out very far

 

I like it! Where did you get it?

 

Cab Mount chop. Only rubbed when off-roading before the chop & fine on the street

Running 285/70r17

 

Anytime camera and stealth charging port tomorrow.

Dropping the truck off on Sunday to get my Icon kit installed, clamshell bushing and LCA tabs lubed in the process.

also have some more Cali Raised bed rails coming in to raise the tent up a little, new diesel heater to test out with the new power station.

 

thanks! SMP Fab in Sunland. SoCal

 

I like it that way.

 

Yeah! Better departure angle!

 

How much front end lift do you have?

 

About 2-2.5”

 

Perhaps a 6-colour rainbow?

 

So does it cut down on water spots after rinsing?

 

Hmm.. So wondering if I’m going to have the same issue at 3” :/

 

Doesn’t one need a license to carry in mass?

 

Yep. Goes on the hose and I use it for the entire process. No new spots after drying. Just sone old spots from before I used it.

 

I did nothing to the Tacoma.. but some a*****e keyed it. Two doors, both bedsides, tailgate and even the fuel cap.

 

Shit! Who’d you piss off! That’s my nightmare! Sorry that happened to your rig.

 

Carbon and sediment filters will only remove impurities (dirt, chlorine, bacteria) from the water. A Deionized Resin tank will absorb hard minerals like calcium and magnesium and prevent water spots. Ideally, you'd have an inline sediment filter then carbon filter then the DI tank. One of these carbon hose filters could be used inline before the DI tank, but they wouldn't last long. Many DI tank sizes and manufacturers are available. The resin lifespan is limited to the water quality entering the tank. The harder the water the shorter the resin lifespan. I use a DI Rinse Pro 100.

https://dirinse.com/product/d-i-rinse-pro-100-system/

 

Damn

 

OOOOHHHHHHHH dang!!! That’s messed up man.

 

Had a little extra time on the way to work and ran the Taco through touchless. Look pretty dang good I think