2023 Sr remote start - start x

Hi,

Looking for some ideas. I installed a start x remote start on my 23 Sr. Everything is working except now my tpms flash's upon startup and will switch to solid. I've tried disconnecting the batteries, checked connections, and did a continuity test of the tpms interrupt which seemed to be okay. Looking for some help on this one.

Thanks

Aaron

 

Double check your connections again at the TPMS wires and also ensure the connector is fully plugged into the remote start module.
If you didn't know, here is how the TPMS interrupt works:
99% of the time your TPMS wire stays connected by running through a closed contact in the remote starter. Everything should function as normal.
Only when remote started, it will open the TPMS contact to disable the TPMS system. This is for vehicles with keyless entry... If TPMS is not disabled, keyless entry will not function.
Good luck.

 

I will try again in the morning and see where I get. Thanks for the reply!

 

Following as I just ordered this kit

 

Is your 23 push-to-start? If so it should be one plug at the passenger side DCM. It will be considerably easier than the key-start version... And no TPMS tapping.

 

No it's not push start. It's an sr model

 

Yeah, I know your truck is key. I wasn't sure about the other guy's trail edition.

 

Mine is push to start , the harness promises plug and play:

 

Yes, you should have a single t-harness. I have that same version in my truck (along with the

$123 ASCL6 Remote Start Cellular Interface Module Allows You to Start Your car from Your Phone 1 Year Included

ASCL6 for cell phone connectivity). Super easy to install, but be careful dropping the air bag out of the way. I would disconnect the negative battery terminal beforehand for extra precaution.

 

Thank you! Will definitely do that.

 

So after you remote crank it, put the key in turn forward then touch the brake pedal the light stays on?

Do you have a scanner where you can erase the error code?

 

So, I installed my remote start kit. It took less than an hour. It takes a little to get the hang of starting it, but it will turn it on and turn it off.

 

You'll get the fob timing figured out pretty quick. Saying a letter between each push might make it more predictable... [push] "A" [push] "A" [push].
If you need to start it from a distance, the

$123 ASCL6 Remote Start Cellular Interface Module Allows You to Start Your car from Your Phone 1 Year Included

ASCL6 module makes it really nice using the carlink app. The cell service is free for the first year, then $99 for 3 years. App gives run confirm and also shows remaining minutes. Also adds gps location. It's an easy add-on to the StartX.