Need Clamshell bearing removal and bushing install tools

I'm going to install the ECGS bushing and was wondering if anyone would have the tools for rent or discount sell. Just wanted to check before I paid retail for a tool I'll just use once.

 

No help?

 

The tool that came with the kit I ordered from east coast gear, didn't fit ended up using small slide hammer at my buddy's shop. You might have lunch finding a used one somewhere.

 

I'd be willing to buy a used one. Just sucks buying a tool that really on has one use case.

 

Same here I've never had to need one till the swap and haven't needed one since, be sure to change out the seal too, I figured the OEM would be fine since it was practically new and it failed a few months down the road.

 

Do you have one I could buy from you?

 

Sorry no I gave the tool away.

 

I've got one, but I haven't done my install yet (I have to coordinate with a friend to use his garage). I'd suggest posting up your request in this thread, which gets a fair but of traffic: https://www.tacomaworld.com/threads/needle-bearing-yes-replace-it-ecgs.716338/page-12#post-28539601

 

Try this tread:
https://www.tacomaworld.com/threads/whoring-out-ecgs-bushing-tool.630638/

 

Hey, not sure if you still need one but I just did mine and I was planning on just holding onto the puller but I'm not sure I'll end up ever using it again. How much were you trying to spend?