What Have You Done To Your 3rd Gen Today?

Mine are in the basement. Along with my front seats. I replaced my front seats with a Scheel Mann set.

 

I went to the dealer way back when and asked him if they sold that bezel and they said only the entire grill... Where the heck did you find one of those?

 

Mounted but not wired. Apparently, my truck isn't prewired for fog lights.

 

Took advantage of the warm weather (45f, was outside working in shorts and a tank top) and got my Auxbeam installed. No more wire mess with dangling relays.

The hardest part was getting the wire around the clutch pedal.
Now I just have to wait for Diode Dynamics to have another sale so I can get some more lights lol

Edit: ignore the dirty engine and leaky battery, that is a project for a different day.

 

Looks nice. Ive been thinking about doing the same.

I was really impressed with the Cali Raised wiring harness that came with my ditch lights.
Made it stupid simple, even for someone so bad at electrical I am known to have "the touch of death" when it comes to wiring things.

 

Got some ORA Rock Sliders installed today by @PhotoDan. Thanks for the hospitality and awesome talk. Can’t wait to get some of your bumpers installed!

 

Looking forward to the report of the condition of the plugs and post-mortem.

 

Look around under your bumper. They’re all prewired. All tacos, 4r, Tundra, and Sequoia come prewired. They’re not going to make different main wire looms at the factory. Brings the cost up too much.

 

baking soda and water will clean up/dissolve that battery corrosion

 

I still have the auxbeam to install and meso puddle pod switch with the runnin4taco panel mount that's similar to that mount. It's just been sitting in my attic, also the hidden bumper dd led bar.

What did you wire the switch to for power?

 

ordered the pedal commander unit. tacoma lifestyle has a 75$ off coupon right now i found. 230 didn’t seem too bad.

sorting through taillights and that’ll be next.

 

I ran the switch power wire to the interior fuse panel, and tapped into "p/outlet no.1" (cigarette lighter fuse)

 

Just thought id share this with you guys. Free cat guards! I have the rci trans skid with the cat guards and love it. Wish this deal was going on when i ordered mine awhile back. Lol

 

Apply a lil heat to that with a heat gun and it’ll pop it out. You could also help it on the other side then bring it to a body shop and they’ll put some bumper bondo on it to smooth it out and repaint it.

 

Right on! I appreciate you cruising up for the sliders and I'm happy to add some protection to your adventure rig!

 

Added a smoker for that full mobile BBQ experience.

 

Most Tacoma’s bumpers stick out more on the driver’s side, you may have fixed it. Seriously though there is a thread on how to realign your bumper, you’d do pretty much the same steps replacing that part in the process.

 

That's a lot of stuff

 

Not terrible. No carbon. They look like they got a hair hot, but that might be normal for iridiums.



And while I was playing with the truck, I impulse bought some component speakers for the front. And I laid another layer of cce behind the plastic.



There's a subtle improvement over the kickers. Sound stage is much more balanced.

 

Not sure about these kind of primitive how they stay on, has anybody tried them?