Pics of trimmed/cut fenders

So I just made the cuts yesterday and driving home I noticed both of my lower orange clips were pulling out in the front. Has anyone done anything to secure them to the truck a little better than the plastic clips? I was thinking about shooting a rivet or two through the bottom.

 

I used self tappers. I also took some 3m emblem tape and triple stacked it up and stuffed up in there in a few spots

 

gonna run to the store to try that now, was a little afraid they might back out and fly into my rear tires.

 

Great thread. I'll be doing some fender trimming soon as well.

 

just did mine at Davids house yesterday, wasn't too terrible to do just have to have a steady hand when cutting.

 

sure does make my 285s look tiny

 

Here's what I did to trim my $120 ebay flares: https://www.tacomaworld.com/threads...ed-flares-on-a-shortbed.662065/#post-23175777

 

Cut 3inches off fender 2.5 off flares 1 inch lift 35s

 

Looks so good dude!

 

Thanks . Work in progress

 

Front flares just barely hanging in there. 3m taped since half the clips are trimmed away.

 

Did you roll your fender?

 

Nada, just cut up to the "curved" part of the flare and the "flat" face of the flare is gone. Kinda looks rolled though

 

Lol, the back crinkled spot looked like you decided fuck it and flared it out.