What Have You Done To Your 2nd Gen Tacoma Today?

You convinced me to finally pick one of these up. Button placement on the EVKCAR controller is a dead giveaway, I can almost guarantee both EVK and Pedal Commander share the exact same circuit board and firmware. Marketing is such a crazy thing to me, extra $100 for what...always thought that star on the controller made it look too brodozer-ish for me anyway LOL.

 

85,950 miles today... checked torque on lug nuts, checked/cleaned the air filter, changed the oil, vacuumed her out...

 

Just broken-in!

 

Cleaned my air filter, throttle body, and MAF, Slotted some brackets to prep for my intake manifold spacer, trimmed some more bumper to hopefully stop some rubbing while flexing.

Also, I really want to trim the front bumper along the natural "line" in it. Pictured below. Just need to find a practice bumper first.

 

Did a little Long Travel deal today.

 

I've been wanting to do something along those line with my bumper as well. I just feel like the early 2nd gens have too much bulk there in front of the wheel.

 

My thoughts exactly.

I used this as my example, but don't want to go that big with it.

Finding a bumper cover for my truck has been harder than I thought.

 

Jump in it this morning and got a P0441 & P0455 code. (Large evap leak). Reset the codes but decided to check the gas cap, just to notice it was never tightened when I filled up.

 

This damn site making me spend money on shit I don’t need. Haha picked one up too

 

Stuck my head under the hood and dash to see where I can run my wires. I have no idea on why I didn't see these grommets before. I can use them to my advantage.

 

So, what do you do if your odometer is stuck on Trip B? I am trying to clear the maint. Light and it won’t even flash. Any help appreciated.

 

Cutting along the relatively straight bumper line will probably look better than the angled corner cuts. The GX crowd does a lot of the straight cuts and they look good imo.

 

First post! Picked up a ‘14 MGM DCLB about a month ago, and found a used shell for it today. Time to start building it out as my surf/camp mobile. Next step is tires!

 

Chasing down why my truck wouldn't 'beep' and lock all 4 doors when I hit the remote. New door actuator solenoid replaced as well for good measure since I had one laying around.

 

What a good idea!!

 

HAHAHAHAHAHAHAHAHAHAH

Fuckin Toyota metal junk.

 

Finished installing KP offroad camber alignment tabs, OEM Lcas with mevotech rough terrain ball joints, rebuilt the power steering pump. Should work well with the jd fab UCAs and kings that were installed less than 10 miles ago.
Also got the last flare, installed some rubber trim on the edge of the flare though that I had laying around in the garage. Still need to find some trim that will go between the flare and body though

next I need to trim the cab mounts more, turn the rear bumper into a high clearance bumper, deal with the skid plates, fix the broken rear window, install the RXT leaf pack, install the front super bumps.
lastly buy rear kings, BAMF shackle hangers, u bolt flip with rear superbumps, a rear diff skid, and if I’m feeling spendy and have some more money a brute force rear bumper

Once all that’s done 37s

 

Wow. How did you do that?

 

Finally installed ss3 fog lights from diode dynamics. They make a huge difference commuting at night, especially where I live it gets real foggy.

 

I'm picking up an off-road axle with the factory locker today.

Does anyone know how throwing that axle under my sport will go? Mostly the abs and whatever sensors are back there? I think I've got the locker part figured out