What Have You Done To Your 3rd Gen Today?

Looks like my garage. I have the Taco and my daughter has a Rav4. They are a great little suv.

 

i got bored and bought a ikamper 3.0 mini that hurt the old wallet

 

That's some great craftsmanship in my completely untrained eyes. What will you be covering the box with?

 

I didn’t have any issues with it being flimsy or anything! I’m sure you’ve seen, but the bumper has the metal “edges” on the sides and it held the plastic in place pretty well. I loved that cut

 

The puddle light switch for meso lights, which is the small button so it’s wedged in there via electrical tape. Anyone know of an adapter for small buttons to fit into the larger button slots? @MESO

Also installed center console storage slots on driver and passenger side. They’re absolutely clutch.

 

If you dont use qi charger i would replace that switch. Or you can buy a new custom panel. I think i have a 3d printed one i bought but ended up not using it lol

I got the auxbeam panel from runnin4taco

 

That is a great thread! I’m getting a shorter lashing strap in case I’m just changing a flat so I can secure the axle to the chassis. Then I won’t need to lift it too much. I’m still waiting on the Lift-Mate. Should work well if I just need to get a traction board under a wheel to get un-stuck. Thanks for sharing the link, good stuff!

 

The attachment was $83.94 on Amazon.

 

Changed out my cabin filter. Lucky to have gotten a few oem filters from the BST



Also got to put in my set of VLEDS for the low beam lights. Love them so far!! These were taken in the afternoon. Hope i can test them out at night soon enough. Cant believe it took me this long to do this upgrade. Matches the DRL really well too

 

Sticker

 

Low pine branch pin stripes. Better on the top than the sides. Put a folding pruning saw in under seat bin.

 

Just installed mid height (17”) Billie Bars, that attached to the t-channel on my Pace Edwards Ultragroove Metal sliding tonneau cover. Now just waiting for RTT to arrive.

 

Went camping for the first time this season in New Hampshire, and test drove my new Topper Tent. Pupper approved.

 

Installed the Auxbeam 8 guage switch panel. Installed new front license plate mount from @ACEkraut. Much better look and easy install, Thank you.

 

I'm about to throw some money on Resonix too. Did you happen to get the Fiber Mat 25 or 45 at all? Trying to figure out what one fits best. I'm planning on just doing the doors and rear wall for now.

 

Done for today. Still need to extend the tow harness.

 

30k front and rear diff oil change and tire rotation

 

I didn’t think the desert were needed with the auto seats

 

https://www.instagram.com/tacoslayer310/

Did an OTT on my manual transmission Trd pro. Ahn was really good at meeting me in Eastern shore Virginia. He did the tune on a medium setting and for me on a manual transmission i didn't like way it felt at the lower gears {IMO}. He met me in Virginia Beach and put on a lower setting. Works for me and takes out some of the throttle lag. I also got this cool patch…