1st Gen Lunchtable Thread - General Discussion

that sounds pretty reasonable to me

 

I'm too dumb to do it myself too so

 

The majority of people that have their wheels posted up don't list in the thread title (or even in the ad sometimes) their location...I mean at least the state so I can either click it or not.

 

@Sperrunner

https://www.instagram.com/reel/Cq25EbLv4JC/?igshid=YmMyMTA2M2Y=

 

Let me dig them up.

 

I should get a CNC mill setup and make intake mani spacers for moar powa

 

The axle seals are notorious for leaking, and I feel like 4Runners being more of a family car would be more likely to go longer not knowing

 

you should buy wheel hoops and cut your own centers to DIY a set of wheels

 

Toyota axles are great except for replacing the wheel bearing after the axle seal fails. Hate it lol

 

Sounds like a plan

Throttle body and intake manifold spacers for more power

Then DIY wheels with some 16 gauge centers for less rotating mass

Anything to make power like the 3rd Genner bois

 

can u make a chakra alignment tool to help me channel my bad driving into 3rd gen ownership?

 

I couldn't sleep so i watched the first 1.5 episodes last night, it's pretty good so far

 

lol these do nothing

 

I put 3 hours into just getting the drum off yesterday, another hour into cleaning. I couldn't even see an obvious spot where it was leaking so this had to have been ongoing for a verrry long time

But I will not be replacing this one right now lol, just want it to be done

 

BuT tHeRe'S a ThReAd NoW bLoWiNg Up about their performance gains, BRO

 

in 2 cylinders

 

Gains are gains bro

 

You want a 3.5 to blow it up, let it idle on a slight incline for 5 mins

 

stolen from the other cylinders, now power across them looks like a bell curve and all your compressions are outta spec