What Have You Done To Your 2nd Gen Tacoma Today?

No dash cam, but definitely might get one now.

 

I drove and drove and drove her today. Basically I went hotwheel hunting. After the newness of the g3 wears off. Nothing like a 6 disc changer and zero traction control.

 

if you don't have a dash cam you're just asking to be the victim of some psycho liar's fairy tale...

 

Had an awesome time at the R4T swap meet today. Copped some Striker hood struts, a sweet little eureka solo tent and a burger. And a sunburn.

 

https://www.instagram.com/reel/Cr3qtiCJLWl/?igshid=NTc4MTIwNjQ2YQ==

Ooooh shit

 

Pro style grille, just did the ultimate headlight upgrade (halogen) to replace aftermarket leds. Damn it man I need to do something about that hood!

 

My hood and roof were really bad. Hood was much worse than yours and roof was dull white peeling clearcoat. I paid a pro shop $980 to strip and paint. Well worth the money as the rest of the truck still looked great. Zero regrets.

 

Used it as a tug to bring the new roomate home

 

Griso!!

Nice.

 

@Oreo Cat


Hey man. Read your account. Sorry you went through that. I hope you can shake it. These folks, while I don’t wish them or anyone ill, clearly they were wreckless, f*cked around and found out, as it were. It’s not on you. I’m a motorcyclist. They had options.
Best to you, man.

 

Brake calipers, pads, and bled the system. Banjo bolts made it easy to swap the calipers, but hopefully the crush washers continue to hold fluid. The red adds 10 brake-horsepower I am told.

 

Installed a 6 switch holder in the center console. I had to do some slight modifications behind the panel.

 

My pop up camper uses a 7 pin, and the HF utility trailer i'm looking to get uses a 4 pin, so this makes perfect sense!

 

My hood looks the same. I'm tempted to try wrapping it myself.

 

Basic 175K mile service.

Oil & Filter Change (PPHM 5W30 & OEM Filter)
Engine & Cabin air filter change
Fresh grease in drive shafts
Tire Rotation
Topped off washer fluid with summer Rain-X

 

Where did you get your banjo bolts?

 

https://www.mooreparts.com/banjo-bolt-short-10mm-x-1-0-threads-pair/

https://www.mooreparts.com/10mm-copper-washer/

 

Thanks, what fitting ? Ive got crown brake lines

 

These are for the brake lines that come with the JD fab LT kit. I am not sure on the fitting unfortunately

 

Right on. not something most folks recognize. cheers