1st Gen Lunchtable Thread - General Discussion

Probably carrying a CV axle for each side, steering rack, lower ball joints for each side, some wheel bearings, a drive shaft, tools, GPS messenger, and a partridge in a pear tree

 

woo!

 

ART DEGREES UNITE

 

Gotta make sure all your lights are on even if it's sunny. Didn't pay all that money fer nuthin

 

OOF

 

Your cutter must do a lot better with smaller cuts then what I had access to in high school. Something like that wouldve warped up real bad. Even with telling the torch to skip around

 

And A FULL HF Rollaway.

 

United in perpetual poverty

BA or BFA?

 

Not an issue at all, then again I don't cut thinner than 16 gauge.

This sign is out of 16 gauge and had a lot of cutting close to each other (due to non-stop heat in close proximity)



But as you can see, no issue at all



The one thing I do have an issue with is beveling that's readily apparent in thicker metals; this is mostly because I need to loosen up the gantry tube and square everything up again

 

Do they carry back up lights for their back up lights?

 

Is your stuff submerged under water while cutting?

 

That's a big reason why, shit I forgot

It's not but there's barely half an inch between the back of the work piece and the water level

I do have a water table with plasma table fluid diluted with water for a 5:1 ratio; the air blasting through (even between cuts) ensures water is constantly hitting the work piece being cut

 

What did the paw say to the face

 

@Sperrunner

Bring Kayden over, I'll get us all buzzed up

https://www.instagram.com/reel/CskNffsJIL8/?igshid=MzRlODBiNWFlZA==

 

Somebody's got some time on their hands...

 

Yeah ours wasnt cutting over water.

 

I couldn't understand why one would get it without a water table (at least when buying one for yourself) but makes sense.

I've been really lazy in that I should clean my table but I've yet to come up with a pump/tank solution for draining and filling.

I bet it can be done super quick and easy but I'm just lazy.

 

Fuck me, I completely forgot.

I can piss off the Overlanders and use my brand new FrontRunner water tank for my CNC plasma table drain and fill.

It's got an 11 gallon capacity which is more than enough.

 

@Kwikvette gorgeous 97 Corolla for sale in Texas.