1st Gen Lunchtable Thread - General Discussion

You right. I should get new safety glasses

 

Buy me some too

Matching bro

 

https://www.instagram.com/reel/Cslq5MUMUBw/?igshid=MzRlODBiNWFlZA==

 

Ahhhhhh I kind of want a set for the Tacoma but I don't want to buy wheels that still require me to use spacers

 

So this is how you download more horsepower, huh?

 

Wouldn't you want it in purple tho?

 

This is me every morning, there's like 1.5 ways I can put my socks on without my hips and lower back hurting like hell lol

 

Just change mother to father.
https://www.instagram.com/reel/Csm2RFOIbLp/?igshid=MmJiY2I4NDBkZg==

 

That's a lesser problem but also yes

 

Older trucks are getting stolen in NoCal like crazy this summer. I have heard of 3 already in the last month. It's time to install a fuel cut off switch on the green truck.

 

*mouth salivating thinking about that insurance payout*

 

*offered $900 due to kbb value

 

Bold of you to assume I'm using the general

 

Just drive it to down town Stockton and leave the key in it.

 

I have not no. It hasn’t been tacked up so I bet it’ll be pulled away. This is one of the other measurements I was talking about

You can see the center of the hole is just slightly set back

 

Maybe I'm not understanding.

What's stopping you from literally moving that piece over where it needs to be?

This could've been remedied right away?

 

It literally will not move I’ve tried bashing on it with a hammer. No matter how I start putting it on it will end up in the same position every time. Safe-t-caps are also suppose to be a perfect fit. You think I just cut more out until it will slide over?

 

It's a safety cap?

That's fabrication right there.

And although their stuff is laser cut, anyone doing fabrication work knows that 99% of the time you will need to cut and/or grind 100% of the time for fitment reasons.

 

If I were you, I would take an angle grinder and flap disc and hit whatever little bit is "stopping" you from moving.

Cutting is excessive, grinding however is required.

 

Yoooooooo!!!

@Wulf just a few minutes ago.